12 8 Control system – 8.2.4 Height limitation 8.2.4 Height limitation page Height limitation, description Height limitation is a part of the control system and prevents the ma- chine from lifting higher than a pre-set height without the operator being informed. Height limitation is controlled by the control system with signals from Sensor boom angle and Sensor boom length. When boom angle and extension indicate that permitted height is reached, lift and ex- tension are blocked and display information height limitation is acti- vated. For details about lift, lower and extension, see section 7 Load han- dling .
8.2.5 Speed limitation page Speed limitation, description Speed limitation prevents the machine's speed from exceeding pre- set value by limiting gear position and engine rpm. 8.2.6 Service indicator page Service indicator, resetting 1 Machine in service position, see section B Safety . 2 Navigate first to the service menu and press Enter. 3 Enter code for resetting service indicator. The code is obtained via Kalmar Industries Support. NOTE The code determines which service menu shall be activat- ed (Service, Diagnostic test, Initiation or Calibration). 4 Reset the service indication by pressing Enter. NEXT SERVICE is changed to given interval.
To change length of the service interval, set the desired interval with the plus and minus key. UDRF01.04GB Maintenance manual DRF 400–450 000056 1 2 3 4 5 000060 1 2 3 004908 SERVICE INTERVALL NEXT SERVICE XXXXh SERVICE INTERVALL STORED XXXXh PRESENT XXXXh