8 Control system – 8.2.2 By-passing 11 8.2.2 By-passing page By-passing, description When the overloading system is activated and turns off the hydrau- lics it may be in a situation where it is necessary to by-pass the safe- ty system. By-pass is activated with a switch, there is one to three switches de- pending on the machine's equipment: Switch by-pass Switch by-pass of load centre and height limitation Switch rotation stop By-passing the safety system makes it possible to:
lowering of load in case of overloading locking and opening twistlocks without full alignment Spreading 20’-40’ with locked twistlocks bottom lift without full alignment manual control of recirculation damper for ECC or EHC release of parking brake in case of malfunction of switch parking brake lift above height limitation rotation past rotation stop load handling past limitation for load centre limitation. lifting, lowering and extension with active error on overloading system DANGER By-passing the safety systems results in risk of tip- ping forward, use at your own risk.
8.2.3 Load centre limitation page Load centre limitation, description Load centre limitation prevents the load from coming too close to the machine. The load centre limitation is controlled by the control system with signals from Sensor boom angle and Sensor boom length. For example, this is used in connection with cab lift to pre- vent that the container damages the cab. For details about lift, lower and extension, see section 7 Load han- dling . UDRF01.04GB Maintenance manual DRF 400–450