D Error codes – 1 Engine 29 UDRF01.04GB Maintenance manual DRF 400–450 Descrip- tion Limitation Action Con- nec- tion and com- po- nent Diag- nostic menu Function group Code Cum- mins code 168/ 18 441 Voltage feed to control unit low. Rough idling. Check fuses. Check batter- ies and alternator. D794/ OEM:7, OEM:8, OEM:17 , OEM:18 , OEM:28 - 11.5.1.3 Igni- tion voltage (15) 175/0 214 High engine oil tempera- ture. Engine power is reduced suc- cessively, en- gine shuts off after 30 sec- onds. Check coolant and oil level in the engine, top up if needed. Check that oil cooler is clean, clean if needed. Check that fan belts are in- tact.
Check sensor oil tempera- ture - EN- GINE, menu 7 1.8 Lubrica- tion system 175/3 212 Sensor oil temperature, cable short- circuited to voltage or open circuit. No display of engine oil tem- perature. Check cabling between control unit and compo- nent. Check that sensor oil tem- perature is connected cor- rectly. D794/ Sen- sor:42 EN- GINE, menu 7 1.8.7 Sensor oil tempera- ture 175/4 213 Sensor oil temperature, cable short- circuited to ground. No display of engine oil tem- perature. Check cabling between Control unit and compo- nent. Check component. D794/ Sen- sor:42 EN- GINE, menu 7 1.8.7 Sensor oil tempera- ture 190/0 234 Engine rpm too high.
Fuel supply is restricted until engine rpm is below permit- ted rpm. - - - - 190/ 10 121 Electric mal- function rpm/ ignition posi- tion, one of two signals missing. No limitation. Check cabling between Control unit and compo- nent. Check component. D794/ Sen- sor:47, Sen- sor:50 - 1.9 Control system en- gine