1 Engine – 1.2.3 Fuel pre-filter 11 1 Machine in service position, see section B Safety . 2 Place a receptacle under the fuel pre-filter. 3 Clean the area around the fuel pre-filter. 4 Drain the fuel pre-filter of fuel and water. Open the drain valve on the underside, close the valve when the filter is empty. 5 Disconnect the wiring from the sensor for water in fuel. 6 Remove the fuel pre-filter with the filter tool. 7 Transfer the water trap to the new fuel pre-filter. 8 Lubricate the O-ring on the new fuel pre-filter with engine oil. 9 Fit the new fuel pre-filter. 10 Connect the wiring to the sensor for water in fuel. Tighten to contact and then another half to three-quarter turn.
11 Turn on the main electrical power and start the engine. Check that the filter seals tight. 12 Turn off the engine and remove the receptacle. Handle the fuel as environmentally hazardous and inflammable waste. page Fuel pre-filter, draining condensation water (Volvo engine) NOTE The fuel pre-filter should be drained of water every 50 operating hours. DANGER Pay attention to the fire hazard when working on the fuel system. NOTE Avoid skin contact with fuel, use gloves. Fuel on hands may cause rashes and irritation. NOTE Wait a few hours until the engine has cooled down before drain- ing condensation water from the fuel pre-filter. 1 Machine in service position, see section B Safety .
2 Place a receptacle under the fuel pre-filter. 3 Open the drain valve on the underside and let the condensation water drain. Close the valve when clean fuel drains (no water bubbles). Fuel pre-filter, drain valve and connector for water in fuel sensor 4 Remove the receptacle. Handle the fuel as environmentally hazardous and inflammable waste. UDRF01.04GB Maintenance manual DRF 400–450