Kaiyi UDRF01.04GB — 1.2.4 Fuel filter

1 Engine – 1.2.4 Fuel filter 13 page Fuel filter, changing (Cummins engine) DANGER Pay attention to the fire hazard when working on the fuel system. Avoid changing the fuel filter when the engine is hot. Fuel may spill on hot surfaces and may ignite. NOTE Avoid skin contact with fuel, use gloves. Fuel on hands may cause rashes and irritation. 1 Machine in service position, see section B Safety . 2 Place a receptacle under the fuel filter. 3 Clean the area around the fuel filter. 4 Disconnect the wiring from the sensor for water in fuel. 5 Remove the fuel filter with filter tool. 6 Change the seal by the filter's threaded connection on the filter holder and lubricate it with engine oil.

7 Fill the new fuel filter with pure fuel. 8 Lubricate the seal on the new fuel pre-filter with engine oil. 9 Fit the new fuel filter. Tighten the fuel filter to contact and then another half to three- quarter turn. 10 Turn on the main electrical power and start the engine. Check that the fuel filter seals tight. 11 Turn off the engine and remove the receptacle. Handle the fuel as environmentally hazardous and inflammable waste. Fuel filter, drain valve and connector for water in fuel sensor UDRF01.04GB Maintenance manual DRF 400–450