1 Engine – 1.7.7 Coolant 19 1.7.7 Coolant page Coolant level, checking WARNING The cooling system is pressurized. Steam or hot flu- id may jet out. A Risk of scalding and burn injuries! Open the filler cap (position B) very carefully when the engine is warm. Wait until the coolant has cooled down before topping up. B Coolant is filled in the system’s expansion tank (position A). The coolant level should be between the MIN and MAX markings (posi- tion C) on the expansion tank. C 004851 NOTE Open very carefully as hot coolant may jet up and out. A. Position of coolant reservoir (expansion tank) B. Filling point C.
Level marking, MIN and MAX If the coolant level becomes too low, the warning light for low cool- ant level lights up on the instrument panel. NOTE A low coolant level may cause engine damage or may cause the engine to stop. 1 Machine in service position, see section B Safety . 2 If needed, top up with water (wintertime with at least 40% gly- col). For volume, see section F Technical data . If glycol is not used, then anti-corrosion agent must be added. However, anti-corrosion agents do not contain any anti-freeze agent and therefore these shall only be used if the outdoor tem- perature always is above 0 ° C. UDRF01.04GB Maintenance manual DRF 400–450