Kaiyi UDRF01.04GB — 1.8 Lubrication

20 1 Engine – 1.8 Lubrication 1.8 Lubrication page Lubrication system, description The engine's lubrication system is a completely closed system and has no connections to the machine. For position of components, see Engine alternative Volvo, compo- nent position page 4 or Engine alternative Cummins, component po- sition page 7 . page Oil and oil filter, change (engine alternative Volvo) WARNING Avoid skin contact with the oil, use protective gloves. Hot oil may cause burns, rashes and irritation! 1 Run the engine until warm. 2 Machine in service position, see section B Safety . 3 Place a receptacle underneath the engine. 4 Remove the drain plug on the engine and drain the engine of oil.

Drain plug, engine from underneath 5 Place a receptacle under the oil filters. 6 Clean the area around the oil filters. 7 Remove the oil filters. 8 Install new oil filters. Lubricate the O-rings on the new filters with engine oil. Full-flow filter : tighten to contact and then another half to three-quarter turn. By-pass filter : tighten to contact and then another three- quarter to one turn. Oil filter engine alternative Volvo TWD1240VE 1. By-pass filter 2. Full-flow filter 9 When the oil has drained, install the oil plug. Torque with max. 60 Nm . NOTE UDRF01.04GB Maintenance manual DRF 400–450