2 Transmission – 2.6 Lubrication 7 2.6 Lubrication page Lubrication system, description The transmission has its own lubrication system that is used for lu- brication, control and cooling of the transmission. The transmission oil cooler is located at the bottom in the cooler unit behind the en- gine, a thermostat in the cooler enables the oil to reach operating temperature faster. At high oil temperature (120 ° C) a warning is activated in Control unit KID (D795) and performance is reduced, if the oil temperature goes above 125 ° C the transmission is disengaged. For position of components see Transmission, component position page 4 .
page Oil and oil filter, changing WARNING Avoid skin contact with the oil, use protective gloves. Hot oil may cause burns, rashes and irritation! NOTE The transmission must not be overfilled! 1 Operate and warm up the transmission oil. 2 Machine in service position, see section B Safety . 3 Place a receptacle under the transmission. 4 Remove the drain plug for transmission oil and let the oil drain into the receptacle. Draining transmission oil UDRF01.04GB Maintenance manual DRF 400–450