2 Transmission – 2.8 Control system transmission 11 2.8 Control system transmission page Control system transmission, description The transmission control unit controls shifting based on pressure sensors, temperature sensors and speed sensors. Gear selection takes place by activating solenoid valves that distribute control pres- sure in the transmission, so that selected gear gives the correct speed. For position of components see Transmission, component position page 4 and section 11 Common electrics, group 11.5.3 Control units . In case of serious transmission problems, the control unit uses two modes with reduced functionality to protect the transmission, Shut- down and Limp-home.
Mode Limp-Home Display on Control unit transmission shows LH. In case of: a malfunction of a control output from the transmission is de- tected. a malfunction connected to a sensor for “engine speed” is de- tected. In case any of the above points occur, the transmission will be placed in neutral position. To enable continued operation, gears have to be selected using the gear selector. two of three “vehicle speed” sensors are defective. In this mode the operator can use the transmission's two first gears in both directions. If the malfunction occurs at a higher gear, the op- erator has to downshift manually to first or second gear to continue.
The control unit uses standard values for modulation. Mode Shut-Down Display on Control unit transmission shows "Sd". The transmission has a built-in secondary solenoid and pressure sensor that monitor the transmission's internal oil pressure. The secondary solenoid is handled by the control unit. When the control unit gives a control signal for “Shut-Down“, the oil pressure releases for all pressure modulators. This happens in case of a serious malfunction. In this mode the transmission is in permanent neutral position as there is no oil pressure to enable selection of a gear. UDRF01.04GB Maintenance manual DRF 400–450