BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMANCHE SERVICE MANUAL 5-16. E1ecaic:aUy Opnud F1ape. 5-17. Removal Of ElectricaUy Opr:raccd Flap Concrob. (PA-Z4-250 and PA-Z ....260.) (Refer to Figure 5-5.) a. Access for the removal of the flap &etUauftimcchanis.., and flap control cables within the fuselqe may be reached by mnovin, the reat teat. Access to the controls in the wiftI may be reached by removing the wheel well splash pan and access plate to the flap beUcrank. b. Remove the flap transmission assembly by disconnecUnc the motor elccmca1lcad$. extracting pin (19) at the rransmission nOUslnS aDd tcmoving bolt (23) at the forward seerion of the aem.tin, screw. c.

Ac:ru.atinl arms (14 and 15) aft removed by cliIConnCC'tinl concrol tabla (2 IDd 5) at the a.rms. the flap position scndCT rod and rcmovin, the pivot bolt at the tOP spar SUP1'ort Nbc. d. To remove the control cable (2) located in the fucJaae. remOl/C the cable pwlcy(s) and disconnect tumbuckle (46) located inside the fuse On the PA-Z4-180, PA-2....250. PA-Z4-260, Serial S05. 24-4000 to 24-4246, 24-4248 to 24-4299 disconnect tension SPrinl (42) with left tumbuck1e. c. The control cable located in the wing may be removed by ellccrinJ throup the wneel well and removing the cable pulley. Disconnect the cable at the beUcrankand dn.w the cable through the fuselage Of wheel weU. f.

To tcmove tbe beUcn.nk. disconnect the flap control rod (33) and bcllcrank mum spring (4) at the bcUcnnk. remove the bolt securing the belletank. g. To remove the left flap mum cable, enter tbroush the wheel well and dilconnett the cable spring (43) at the inboard side of the wheel well. DiIeonDeet the other CDd at the lcadi", cdcc of the flap. h. Removal of the riPt flap mum cable and st~ lock mechanism is accomplished by disconnecting the 1'CtUtn spring (43) at the inboard side of wheel well. Remove the aft winJ fairinI. the access plate located at the inboard. under side of flap. and baclt the adjustiDg nut (41) off the cable CDd..

Unbolt step lock pulley mechanism (44) and withdraw support cable. SURFACE CONTROLS ISSUED: 8/1Sn2 IG9