PIPER COMANCHE SERVICE MANUAL s-is. InstaUaaon of EleariClJly Operated Flap ConClO". (PA-Z+-ZSO and PA-24--260.) (Refer to FiJure '·S.) a. To install the flap aetll&tiDg mechanism UlCtftbly. connect the &CQI&tiDg anns (14 and 15) to the upper spar suppOrt tube and insert the pivot bolt. TiPam the bolt to a mill fn: with no binding of the anns. ConMct the flap position sender rod (1.2) to the ICtUaQq ann. b. The ae:tuaM, motor and tranSmission may be installed as a unit. NOTE Refer to LllbricmOD Chart. SpeciallDmuetions for specific lubricuiOD instnlmons of flap craDIIniuion ..-mbly.
Place the uansmission end bmrtcen the two brackeoladint from the spar SlIppon:, insert lockinl pin ( 19) and safety. Connect the tn.nsrnission ICtUatift, screw (22) to the lower portion of the ae:tlWing ums. insert bolt (23) and sc.:ute. Connect the deetriCllllnds to the motor. referriDt to the electrical dilcnm in Section IX. Operate the motor to IIIUn proper elcaric:a1 hookup. c. The flap beUcrank (6) may be inallcd by placiDl intO pOlition. inIaWDI the pivot bolt scc:urinc the bellcrank and tilhten to a snUi fic. InstaIJ. the flap contrOl rod(33)aad bcUCJ"Ink rnum spr1nc (4). d.. The concrol cable that leads from the fulCl.
to the winl may be iDsWJcd by coanec:ting the able to the bellc:rank and drawinc it throup tbe win. into the fulelap. Enter thro. the whcc1well and install the able pulley. e. The c:oncrol able ( , ) that is within the fusdaIe should be CODllectec:\ to the winS cable IJId flap transmission lCtUatinc ann U$). InIa1l cable paUey(s). On Serial Nos. 24-4000 to 24-4246. 24-424S to 24-4299 connect tension SPrint (42) to the cable md of the left tumbuc1cle. i. To install the flap rftUm able (27) in the left win,. mter through the wheel well and place the return cable through the crailine edce of the win,. Connect the cable to the leadin, edge of the flap.
raise the flap and connect the retum sprin, (43) to the bracket loc:ated at the inboard side of the whftl well. g. The combination flap teturn and step lock usembly(44)in the richt wine is installed by mtmng through the wheel well and installin, the 'step lock mechanism with the cable Wftpped around the pulley and secured, Insert the able md to the flap. through the trailing edJe of the wine and into the flap. SW"t the adjusting nut (4$) a few threads onto the cable end. Draw the tmsion ",riftC (43) in place at the inboard side of the wheel well. Place the flap rctrIcaon cable to the aft side of the telease ann pulley (3).
AJeertain that the step lock will disenpee aad enpte when the flap is retracted. h. Rig and a.djuSt per Parqraph '-19 and reiftstall access panels. wheel well splash pan. rear scat. etc. NOTE Seal exterior access panel with tinc chromate tape applied to pant'l and fuscJqe. . SURFACE CONTROLS ISSUED: SI1Sn2 IGIO