P1PER COMANCHE SERVICE MANUAL S-l9·ROn. ADd AdjUJdD. Of Elearically Opcrued F1ap ComroJa. (PA·Z.... 250.nd PA-Z4-260J (Rder to Figure 5-5.) L Adjust flap control rod assembly (33) to lcncm of 5-5/16 inch from center of bole in rod end beari.nl to center of hole in the fork. b. With the: cables discOMceted .t the conlrOl UIIII (14 and 15) adjust the down UaDit switch (9) 10 the: ama.tiq screw aacmbly (:z:z) .extends to 14.1%5 * .06% iDcbcI mcuured &om forwud face of the tnnsmaon bousin( tl) the CentUMe of the attaehmcDt bolt at the lower eDili of the control ums. With the &C't'Uatinc screw extended. conn«t the cables aDd adjust the aambuckJa to ret 3%. of flap deflection.
The tumbuckles shoWd be safctied at this time to maiDtaiD tbiI adjt.uaDtIlL c. w.em.ct the flaps and adjust the up limit switch (1 1) to obaiD .750 iach it .1%5 inch slack in the riFt flap cable. (Refer to FilUft 5-S, View A-A for Propa' locacion &lid procedure for mcuuriq .750 inch s1Ick.) The left cable 'Will bave more slack thaD the ript due to tbe Step lock wbidl is not installed on the left side. Therefore, it is nccasary to hook the cable .pport JPriIII (42) tbrouP the bole in the inboard cable eDd tcrminal. PClition the flaps in the U· ClttCIIdcd 1ocation. Thea adjust rod (l:Z) 10 the hand on the flap position indicator on the iDmwncnt pad is positioned It the bottOm of the white arc.
d. The step lock cable, at the ript flap, maybe adju:ed by rumina adjustinl nut (4S) until approximately .125 inch play exisa in the flap. e. Operate the flap system and check for proper operation. Check asmbuclrlcs and push-pull rods for safeties. NOTE When detetmininl the deflection liliie of the flap llIC a bllbble protractor. The angle betWeen the aircraft leveq hap ud the flaps when they arc fully rctra.Cted should be 13·. when the flaps are fuUy extended to 32· the angle should be 4'·. Tolerances are * 2·. Measurement of flap anpe is taken panJld with and next to the rib rivetS 23 inches from the inboard end of the flap.
NOTE Occasionally flaps are adjURed to COGlpcftl&te for winI heaviness with an adj\lStllleftc screw located bftwCCD the cencer roUer bndteu of the flap. One flap may be adjusted with the cn.i.UzaI cdce below the nClltral position to comet willa heaYins. The mlXimwn disWlCC allowed below the DClltral position is three rums on the adjusancnt screw. Tbe screw should be readjusted after rigi.ag is completed. SURFACE CONTROLS ISSUED: 8118n2 IGll