PIPER COMANCHE SERVICE MANUAL '·24. Rudder Conn". '·25. Removal Of Rudder COGO'O (Rder to F:ifun: 5·8.) a. Rotate the two vertical Nmbuckle bands (21) to relieve tasion from the rudder control cables and disconnect the forit end of the tumbuckla from the pedal UlGnbly. b. To ranGYe the Ndder pedal contrOls. disconnect the ",ht and left meriD, rods (22). remove the two bolts (23) scc:uriJW the riJbt side inboud pedal and the n,ht and center baMI blocks (24). Those aircraft ўquipped with eee brakes. disconnect the brake concrols from the Ndder concrola. Slide the tube from the left bc:ui.nJ block and brine the pedal URmbIy out mm the left side.
Disconnect necessary concrols to faciliate mnonl of pedal utembly. c. The rudder contrOl cable may be removed from within the fuse. by removiJII the upper fusdage tail cone fairin,. accas panel on the rilht side of fuIdate just ahead of sabilator. die forward left floor panel. bagqe CompuanCflt floor panel and rear bulkhead panel. Dilconacet cable at the rudder hom and remove the cable pards from the rudder pulleys. On the PA-24-260 Serial Nos. 2..... 783.24-4804 and up. and PA·24-400 aircraft, disconnect the ruddCMilcron intCfCOlUlcct cable by mnovinl sprilll artaehmcnt fitting from the Ndder cable. Draw the cable from beneath the floor panel a. To install the rudder pedal concrols.
place the pedal UICftlbly into position from the left inside of the fusc1qc. Slide the tube into the left barirII block. install the c:ertftr and richt bcarinl blocks (24), lnsu.ll the twO bolts sccurilll the ",ht side inboard p«lal and steerinI rods (22). Connect btUe controls if installea. ',26. InRIiJadon Of Rudder Conuoll. (R.der to Fipft 5-8.) CAlT110N When sairJIinI the cables on the front pulley duster just an of fire wall. be sure to thread cable in the puUcy groove and not over top of either the front or bottom cable guards. (Refer to View A·A of Fiprc '·8.) b. The rudder concrol c:able may be installed by drawinl the cable from the rear of the fusciale. beneath the floor panc:l.
around the pulley cluster at the fire will to the rudder conrrols. On the PA·2~260 Serial So 24-4183. 24-4804 and up. aDd PA·2~ aircraft. connect the rudder-aileron intercolUlect cable by insu1ling the sprin,anachment fitting to the rudder cable at the swaged ball fittiftJ (20). c. Connect the cable at the rudder hom and secun:. Ria :and adjust per PaJ"III'&ph '·21 and install panels. fairings. eee, a. Ascertain that the nose geu is propcriy aligned wid! the rudder pedals according to alilnment of Sosc Landing Gear. Section VI. b. Check. and if required. adjust Nddcr for neutral alignment with relation to the neum.l position of the rudder pedals.
and cables for comet tension u required in Tablc V·l. The foUowing procedure may be used: '·21. RigiD, ADdAdjulanCllt Of Rudder Controls. SURFACE CONTROLS ISSUED: 8118nZ IG14