BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMANCHE SERvtCE MANUAL 5·23. Rigjnl And Adjustment Of Flap Control. (PA-2~.) (Refer to FilUre S·5.) a. Adjust the flap control rodCH)to a \enJth of ',5/16 inch from center hole in rad end bcari,,! to center hole in fork. b. With flap push-pull cables disconnetted. adjult the up limit switch (11) (rear switch) to obcai.n a dimension of .375 inch ... . 062 inch betWeen forward face of a'IDIIIlission bousm, and rear edge of the mnsmission sleeve assembly (%2). MeWe the flap selector swath in the down powon. moviJll the contrOl arms (14 and 15) away from the up limit swilch (11) until the adjustmCllt screw is clear of the up limit switch.

Move the selector switch to the up position and let the system deactivate iacif. check the .375 inch dimension. NOTE When detmnining the deflection anile of the flap usc a bubble protractor. The anpe between tbe aircraft when Icvd and flaps when th~ are fully retracted should be 13·, when the flaps are fully extended to 38· the angle should be 51· * 1· . Mcuumnent of nap antIc is taken parallel with and next to the rib rivetS 23 inches from the inboard end of the flap. NOTE Occasionally flaps arc adjusted to compensate for wintJ heavincss with an adjustment screw loated between the center roller brackets of the flap.

One flap may be adjusted with the tnil.iq edp below the neutnl position to correct winl heaviness. The maximum distance allowed below the neutnJ posicion is three turns on the adjusancnt screw. Tbe screw should be re.djustcd after.ftI is completed. c. Place the flaps in full up position and adjust the clevis fit'tiDB on the control arms (14 and 1.5) so that the clevisbolt may be illllCtted throuah the clevis aDd th~ slot in the conuol arms (14 and 15). The bolt should fit snUB acainst the forwani radius of the slot in the control anns (14 and 15). Ascauin that a wire cannot be inserted throu.h the minimum thread bole of the devil ends both in the cockpit and winp.

Secure in position with the jam nuts. d. With the flaps fully retracted. adjust the step lock release cable within the fuselace so there is no slack in the cable and the step lock cable adjustinl nut (45) at the flap to .125 inch mvel in the flap. e. To make the flap down adjustment. run the flaps to a measured 38· down position. The down limit switch (9) adjuStment screw is thcn tumed out until the down limit switch is activated and then screwed OUt an additional 1/2 rum. Secure adjustment screw with jam nut. Retract flaps to dot adjustmel'lt screw from switch. then extend the flaps allowiftJ the system to deactivate itself and check flap travel, f.

Position the flaps in the 15 0 extended loacion. Then adjust rod (12) so the hand on the flap position indicator on the instrument panel is positioned at the bottom of the white arc. Op~tc the flap system and check for proper operation. Check turnbuckles and push-pull rods for safeties. SURFACE CONTROLS ISSUED: 8/18172 IG13