PIPER COMANCHE SERVICE MANUAL 4 4 AIRCRAFT Ck: l. Co c c 1. aU LEP~OT~ACTOR 2. "Aa~'C:AT&D LEVELING aAR 3. ATTACMMIENT 80LTS ACCESS HOLES STAalLATOA ,"OltT lola 0" I.IVal.lNO TOOl. ,"OIt ltO 0 ... ""O ...T ..... ca 0" S..... '" ... 'UI. ... 1. TO~O" .'ltC''''''T. FIGURE 5-11. CHECKING STA81LATOR TRAVEL the bearings be removed from the torque tube. note the number of shims. if any. between bearing and robe collar. 5·34. lnftalJarion Of SabiJacor COllaol•• (Refer to Fifgre '-10.) a. Should it have been necessary to remove the bearing blocks from the torque robe. check that there is a dimension of 8.620 inches from center of the right bcarin, block to center of the left bearing block.
.\iaintain this dimension by placing the necessary shims betWeen the bearing and rube collar. Insert the balance urn into the fuselqe aneislide the bearing blocks intO position. Install the aim mechanism brackets and secure torque tube auembly. b. The aim mechanism may be installed. referring to panpaph ',38 anei the subilator surfaces referring to parap'aph +-35 of Section IV, Before conncctml any contrOl cable. check for proper balance of the subilator. (Refer to Section IV.) c. To insull the forward connol cable (43), commence by IDCUUftnt from the thimble of the cable end (not identified by paint), approximately 151 inches to the nr.ed ball at this point.
This ball will connect to the left con1:r01 column bnrina. The swaged bill that: is approximately 178 inches from the thimble of the cable end (identified by paint) will COMea to the riJht connol column bearing. String the cable loS shown in Figure '-10, secure the SWIlled balls and pulleys (44). Draw the cable ends down around the pulley cluster. beneath the floor panel and to the ahseaion of the airc:nft. Install the remaining cable guards or pulleys (,). CAUTION When stringing the cables on the front pulley cluster just aft of fire wall. be sure to thread cable in the pulley groove anei not over tOP of either the front or bottom cable guarcis.
(Refer to View A-A of FifUl'e '·10.) SURFACE CONTROLS ISSUED: 8/18/72 181