PIPER (OMA~CHE SERVICE MA~l'AL d. The aft -tahilator control cab~e!'t m~y be connected to the stabilator balance. On the PA-~..1-I. PA-24-~50 and PA-2~-2~O. the cable with thimble end goes over the upper pulley and the cable w it h t swagged ball and forked fitting goes to the bottom. On the PA-24-400 the shorter of the two vimilar cablc-, go 0\ er the upper pulley. Connect the aft control cable- to the forward cable. Match the painted end~. Connect the stabilator extension -pring (~Il and cable. e. FM the rigging and adjustment of the stabilator controls. refer to Paragraph 5~~5. 5-~5. Rigging and Adjustment of Stabilator Controls. a. To adjust the stabilaror controls.
first ascertain that the stabilator is properly balanced. (Refer to Section 1\'.) b. With the aircraft level. determine the level position of the stabilator by use of a bubble protractor on a special leveling tool placed on the -rabilator per dimensions in Figure 5-11. The leveling tool min he fabricated per dimensions given in Figure 5- D. Set the stabilator travel by adjusting the star holt, at the torque tube horn (refer to Figure 5-12) and measuring the degree of travel with the bubble protractor on the leveling tool. Trax el dimensions from level are given in Table \'-1. c. To vet stahilator control cable tension. place the control wheel in neutral position.
Measure trorn the instrument panel along the under side of the control column to the control W heel. Refer to Table \ -I lor appropriate dimensions and cable tensions to obtain the stabilator neutral position. 'OTE Srabilator should hit stabilator stop bolts before control wheel shaft in cockpit hits stops. d. Adjust link at -rabilator control extension spring to obtain .I::!5 inch slack in cable \\ it h stabilator stops adjusted and control wheel in full forward position. 5-~~. Stabilator Trim Controls. a. To remove the trim mechanism or control cable. tension must be relieved from the control cables. Rotate the turnbuckle barrels (5) located in the aft section of the fuselage. b.
The Iorward trim cable may be removed by lowering the overhead light panel. gaining access to the forward most pulleys ( II. Disconnect the cable at the turnbuckles. If the cable need not be reused. cut ant:' end of the forward cable (::!) and butt the new cable to it. solder the cables together and smooth the joint. Should it be necc-sary to reuse the old cable with the thimble. etc.. attached. remove the trim crank and idler pulle~~. 5~n. Removal of Stabilator Trim Mechanism. (Refer to Figure 5-10.) Lower the headlining. and remove the necessary cable guards to facilitate removal of the cable through till' bulkhead-. Withdraw the cable from its position. c.
The trim mechanism with the aft trim cable may he removed bydisconnecting the trim tab actuating arm. rernov ing the cable guards at the pulleys and disconnecting the trim indicator wire. Disconnect the tab bellcrank a" .. cmbly and the unit at the support bracket. ISSl'ED: 8/18/72 IH2