BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMANCHE SERVICE MANUAL '·38. IDitIllaIion Of ScabiJacor Trim Mechum. (Refer to Figure '-10.) a. To insWl the stabilator trim mechanism. UMmble the c:lmm usanbly (10) onto its support brackets, AtUCh the bellcnnk (34) to the bea.nn, blocks md salety. Dn.w the trim abies (2) into the fuselage.allowing them not to era and instaU the cable pulleys. b. The forward trim cable may be iNaUed by dnwinl the cable to the location of the trim crank. pulley (1) and idler pulley. Wrap the able around the cnnk puDcy,then to the idler pulley and back to the crank pulley. Continue the cable to the an section &nd insa1l cable pulleys that were removed.

Co To rig and adjust the trim mechanism and cables. refer to PantnPh '·39. '-39. Rigin. And Adjusancnt Of SabiJaCot Trim Mcchailm. a. To rig the nabilator trim syscem.draw the trim cable. rontiftl the cable drum until approximat:ely 7 wraps (PA·Z4-180, PA-Z4-ZS0 and PA·Z4-Z60) or 8 wraps (PA-Z4400) remain on the drum of the tOP seriesof wraps. b. Within the fuselage. draw the forward trim cable fore or aft and connect the tumbuckles. Should it be necessary to swage a cable end before connecting the remaini,. t'Umbuck1e, UMmble the eye. thimble and sleeve. Connect the ends to the barrel with three or four thracis. Draw the free cable end until it is titht.

clamp the able so that it will not damlle the cable or slip back. Crank the trim a few times to SUt the able on the drum and pulleys. Apin draw the free end of the cable to approximately the required able tension (refer to Table V-I), sw. the sleeve to the cable and ract the cable tension. Cut off the remaining able. c. Without tumin, the trim drum, rotate the trim screw until .28' (PA-Z 4-180. PA·Z4-Z'O and PA-24-Z60) or .210 inch (PA-Z4-400) exist between top of the clnam housiftl and bottom of the upper screw no!'. (Refer to Filure 5-10.) The trim drum and screw are in neutral position. Connect trim screw and bellcrank. d. Level subilator IS described in Parqraph 5-35.

Adjust the seabutor tab ann 10 that the miling edies of subilator tab and stabilator aliln. Ascertain that there is one cable wrap rcmainin, and there is no binding of cables or turnbuckles when the trim is moved throu,h its full mvel. Readjust if necessary by resetting the trim screw and drum. e. Reset the nabilator and tab at .ncurral and adjult the trim indicator within the fuseille to read neutral by setting the wire at the reu of the fuseille. CAtrrlON Upon completion of all installations and adjusanents, before any flight tests. check that all controls are hooked up and riJpd properly, turnbuckles. bolts. eee, are safetied. and panels and plates are secured. f.

If the subilator tab is not aJilned with the neutral subilator. discoMecr the Stabilator tab actuator rod (35) from the bellcrank (34) by rcmoYiftl the eeeeer pin. castellated nut, washer and bolt. Loosen jam nut and rotate rod end bearing (33) unnl the trim tab and stabilator 1ft aligned when the rod end bearing is in place. SURFACE CONTROLS ISSUED: 8/18172 IH3