·.at PIPER COMANCHE SERVICE MANUAL ... _;:sa = 1. ITO_ IOL TS Z. TIilIM TAe INClCATCIil AIlIM 3. TIilIM TA. CONTIIlCLCAeU &. TIilIM TA. INOlCATCIll WI IIIIE \' '~ 3 FIGURE &.12. STABILATOR ADJUSTMENT POINT NOTE Tbe subilat.r trim contrOl rod end bnrift,locaml at the forward end of the COQuol rod (33) should be checked for freedom of movement dunn, the replat 100 hour iDlpcction by disconnce:tinl the rod at the trim tab and holdint the end between your ranpn, try to aam the rod from side to side and rowe up and doWft. If the rod will not tum or is hard to tul'1l, the bcarinr should be checked more thorouthly by rcmoYinl the complete assembly (33) from the airplane. g.
Connect the tab actuator ann to the beUc:rank ac the rod end bearinl with bolt, wuher. castellated nut and cotter pin. With the subilacor in the neutnl position, tum the trim in each direction to screw stOps to check tab anile u Jiven in Table V·I and also check minimum number of wraps left on the drum. (Minimum allowable is one and one quamr tums.) 5-.40. Wrappilll Scabi1acor Trim Drum. (Refer to Fiprc 5-10, Sketch 0 or G.) a. To wrap' the trim drum, aKauin that the screw and drum IIICmbly is removed from the aircraft. b. Locate the center of the rear trim cable (%), mcuunn, from end to end. II\lC1"t the trim cable into the drum slot aDd install lockpin.
Mark one end of the drum (16) to be tOP u it will be insuJled in the aircraft. The cable from the top of the drum wrap down in a clockwise diremon 9-114 tums. the lower cable wrap up in a counterclockwise direction 9-1/4 turns. Insert the drum into ia frame (10). Insert trim screw (11) throUJh the drum and inall screw stops (14). Maincain a muir-nun of .00% betw~ bushing and drum. Install the two brKket anpcs OS) to the drum frame with the suppOrt side bracket bolts installed. Install the two cable pards and center the drum between the twO screw Stops. The drum assembly may be inStalledon the aircraft, mer to Puqraph '-38. SURFACE CONTROLS ISSUED: 811Sn2 184