PIPER COMANCHE SERVICE MANUAL sEcnON VI LANDIN(i (if U AND BRAKE SYSTEM 6-1. Incroduction. Contained in this section are inscructions for tr'Oublcsboocint. overhaul. inspection and adju.stment of the PA-24-180. PA-24-0250;'PA-24-Z60 and PA-240400iandinl par. landint ,car tctnction system and brake system. Also, adjumnena (or the ciemica1 safety, down limit. up limit and warning switches. 6-2. Description. The PA·24 Comanche tricycle landiq JCI1' sy.em is an air-oil oleo type unit that is electrically operated. fully retractable with the aese ,car retn.ct:inI aft iDto the GOIC section and the main gear mractinl inboard into the wing.
Gear doon operated by par movement pvti&l1y cover the par when The retraction mechanism consistS of an electric mocor and traDSmission assembly. torque tube assembly, push-pull cables to each main aar and a push-pull tuM co the nose ,ear. Limit switches arc installed in the system to cut off the tnIUIIUssion motor when the pat is fuUy cxtenclcd or tctracted. These switches also operate par indicator liFts in the cabin. To prevent the gar from retracting while the airplane is on the ,round. an anti-retraction safety switch located on the left main par will not allow the ,eu to retract until weight off the gear hu allowed the st:Nt to exrcnd to within three-quarters of an inc:h retracted.
of full extension. When the manifold pressure is reduced below 10 to 12 inches and the landing gear is not down and locke4. a waminl hom will sound. In the cockpit. located bct'ween the pilot seats. under the floor panel. 15 an extension handle used to manually extend the Iandm, gear while in night should It become necessary. Also. it may be \\SCCI to extend and retraCt the ,ear when the airplane is on jacks. The brakes are hydraulically actUated by one muter cylinder on the early models and individual muter cylinders mounted on the left (optional on the rilht} set of rudder pedals on the late models. A reservoir. located on the forward side of the firewall.
supplies hydraulic fluid to the muter cylinder, From the cylinder the fluid is routed thr0ueh lines and bOla to a parkinc brake valve located under the floor panel In front of the left pilot's seat on the early models. or on the muter c;ylindm of late models. The rluid is then directed to the bra.ke assemblies on each main landinJ ,car. The brakes arc self·adjumn,. singie-disc. smgle housing, double piston usemblies. To operate the brakes. pull the brake lever back on the early models and apply toe pressure to the tOP of the brake pedals on the late models. The parking brake may be actUated by applying the braKes and pulling out the parkin, brake handle. To release the puking brake.
apply the brakes and push in on the parking brake handle. 6-3. TroublcshooQn', Troubles peculiar to the landing gat system are listed in Table VI·II at the back of this secnon, along with their probable causes and' S\IIIcstcd remedies. When troubleshooung. check the power supply and ground of the items aifeC:tcd. If no ttouble is found. the trouble probably exists inside :ndividual pieces of equipment. 64. Landing Gear System. IH22 LANDING GEAR AND BRAKE SYSTEM ISSUED: 8/18112