PIPER COMANCHE SERVICE MA~l'AL m. The steering bellcrank (I}) and aligner guide (II) may be removed by removing nuts. v.ashers. bolts securing the steering rods (15 and 16) to the bellcrank, the nut. washer and bolt securina the alizner I! tang to its bracket and the nut. washer. bolt and bushing securing the steering bellcrank to the la;ding ccar mount. a. Clean all parts with a suitable dry type cleaning solvent. b. Inspect the gear components for the following unfavorable conditions: I. Bolts. hearing and bushings for excess wear. corrosion and damage . .., Strut housing. drag links. torque links. fork assembly and fork tube for cracks. bends or misalignment. 6-D. Cleaning.
Inspection And Repair Of Nose Landing Gear. 3. Downlock spring for corrosion and wear. and serviceable limits. (Refer to Table VI-I\·.) 4. Check the general condition of limit switch and its actuator. wiring for fraying. and poor connection or conditions that mav lead to failure. 5. Check all polished' surfaces for scratches and nicks. 6. Check the drag link assembly. (refer to Figure (1.-3) through center trawl of both the right ( 11 (35) and left (:!l (34) drag links. by placing a straight edge in alignment with the center of the rear and forward drag link attachment points. (See Sketch A of Figure 6-3). Ascertain that when the stop surfaces of the 1\\0 links touch.
the center of the pivot bolt (32) is .187 + .062- .00 of an inch below the straight edge. This check may be cond ucted on a surface table using a surface gauge. I fthe drag links are not within the giv en tolerances. replace on or both drag links, c. The shimmy dampener requires no service other than routine inspection, In case of damage or malfunction. the dampener should be replaced rather than repaired. d. Repair to the landing gear is limited to reconditioning of parts. such as replacing bearings and bushing .... smoothing out minor nicks and scratches. and replacement of pans. ti~14. Installation Of :\ose Landing Gear.
(Refer to Figure 6-3.) ~OTE When assembling any units of the landing gear. lubricate hearings. bushings. and friction surfaces with the proper lubricant as des- scribed in the Lubrication Chart. Section II. a, Install the steering bellcrank and alianer assernblv as follows: I. Attach the st~eering bellcrank ( I~) and aligner assembly (II) with washer and bushings to the engine mount using. bolt and nut . .., Attach the tang of the aligner to the aligner support bracket and bolt. washer and nut. l Connect the steering rods (I5 and 16) and rudder trim control rod to the bellcrank wit h bolts. washer ... and nuts. b. The landing gear oleo housing (5) may be installed as follows: I.
Position the nose gear to allow the support arm of the housing (5) to align with the support fiuinas on the tubular mounrinu structure ( 17), - "I Install spacer v.a~hers (X and 19); evenly and as needed to allow no side thrust (a maximum of two washers arc allowed on each side). between the support arms and the support fittings: and attach each arm to the fitting with bolts (9 and 10). washers and nuts. Do not safety attachment bolts until after the adjustment of the drag links has been completed. 3. Extend and retract the gear to determine that the screw head of the aligner roller (II) clears the inside web ot the aligner guide (61. LA~DIJIllG GEAR AJIllD BRAKE SYST. RE\'ISED: ~/10/8t 118