BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PtPER COMANCHE SERVICE MANUAL c. The drag Iinkund downlock s"rint may be insalled u foUows: 1. Ascertain that the upper (18 and 18) and lower (34 and 35) draa links arc assembled. and throulh travel of the links is chedted accordq to parapph 6-13. Allow the clnc link erou bnce (30) to remain loose until the adjustment of the links is completed. 1. Attach the upper dne links (18 and 18) to the CftIine mount support, at the fimnlL with bolts (12). wuhcrs. nutS and cotter pins. 1nsaJ1 spacer washers (11). nOt to exceed two. between t!te 1m dl'lliink (28) and attachment fitti", to atW.n .fficient danace between devis (27) and fuselqc. 3.

Attach the lower drq links (34 and 35) to the strut housinl (5) uli", bolt. Do not secure bolt with wuhm. nut and cotter pm until af'tf!r adjumnent of drq links. 4. Check adjustment of dnf linkJ todctmnine that they lock u i1dtnacted in panpph 60-15. 5. Secure the drq link croll brace (30) IIId .ftty mnainm, nUD of the attachment bola. 6. Connect the downlock sprinJ(s) (33) between the fininp Oft the par hOlllilll and link ctOS1 brace. Piper Kit 761 082 Ibould be iua11ecL d. Install the leat down limit switch (29 or 43) on iu Iftoununa bndtet on die left drq links and adjust as given in pUlCftph 60-53. e.

AttaCh the end bearing of the mraction.push-pull rod (1') to the dne Unlr c:kvls (27) llIiftl bolt (26), wuher and nut. The had of the bolt (16) with the countersunk portion is to the left or outboard. Also. check adjustment of both the dIll link clevis and the P\llhl'uU rod u pen in pansr&Ph 60-56. f. Check alipmcnt of the nose Iandi", par per panpaph 6-16. ,. Install the bottom cowl and air intake bOlCS. b. Connect and adjust the ,car door per parwJnph 6-17 or puqraph 6-12. 6·15. AdjUlCIMDc Of NOIC Gar Drat LiIl1cl. (Refer to Fipre 6,3.) a. To adjUst dnt links. fIrSt remove the bOttom cowl by dilconncetinl the nOle acar door aetuatiftJ rod.

air intake hoses at the bottom cowl and rerDovt .. anachint screws. b. Place the air1'lane on jacks. (Refer to Jackina. Section 11.) c. Disconnect the rm&ction push-puU rod (15) at the left drat link (11) by ftnt recrac:tinc the par enough to aliln the connccting bolt of the push-puU rod and drq link clevis (17) with the eee inch hole in the adjacent IOftlinadinal channd and then rcmoviftl the nut. washer and bolt (16). d. Remove the downlock spri~s) (33) from between the gar housi"l (5) and dna link cross bnce (30) by rcmovinl the nuas). wuhm.s) and bolt(s) that Itt\lre the sprins Unk(s) to the cross brace. e.

Loosen dne link cross brue &ttachi"l bola enouth to &11ow the bnce freedom to rotate but Dot 5epa,.ce from either dl"lliink. f. Check that there is no excaa war in the bushinp and bola of the drat link aucmblY· ,. Ascertain that when the upper and lower dna links arc UICnlblcd. the throup tn..,.l of the links is within the limits given in p~h 6·13. h. Extend and retract the nose JCU manually to check that each link URmbly locks simuluneously and indcpcndendy of eath other. Should one or both links not lock u required. adjustmentS may be made as foUow,: NOTE FoUowinl adjusanct to any of the three pan in _bidl the control tubcsJrod were disconnected widl the aircraft on jacks.

the transmiuion disconDCe:ted. uc:en:aiD that aU three ,ear draa links 10 over centCf and lock at the same time iDdePmdCDdy of each other. 119 LANDING GEAR AND BRAKE SYSTEM REV' SED: 4/3118