PIPER COMA~CHE SERVICE !\1A~l'AL FIG1'RE 6-4. C:lA\1PI~G Rl"DDER PEDALS p, ~ErTRAI. POSITIO~ FIGl'RE 6-5. Rl'DDER PEDALS :\ T SEl'TRAl A!'iGI.E 1.t9-fl-I~: 1.00 dia.. P '\ 14175·1)3) to obtain proper adjustment. b. Two methods of aligning the nose landing gear are as follows: I. Chalk l.ine Method: (a I Place the airplane on a hard level surface and place on jacks. (Refer to Jacking. Section fl· (fl. Alignment Of ~ose Landing Gear. a. With no load on the nose \\ heel. make sure no gaps exist at the points where the steering arm bushings contact the steering "bellcrank but will allow the bushings to rotate with a slight drag, l n-tuil hushing- I.fl25 diu .. P :\ 1497(,-23: .61n dia ..
P ~ 14976-21: .lH2 dia .. P ~ 14976-102: .750 dia .. P " II. I (bl Install the plumb bob attachment tool on the forward edge of the lower fire wall flange, or on the two nose gear brace tubes as shown in Figure 6-6 and attach a plumb bob to the tool. (Thi- LOl,1 may be fabricated from dimensions given in Figure ft-31L) (cl Attach a plumb bob to the fuselage one-half inch to the right from center of the tail rd) L'sing the plumb bobs as a guide. snap a chalk line extending several feet beyond each hob. (e) Stand in from of the nose landing gear and orient the tire with the chalk line, Sight along the center rib of the tire.
With the rudder pedals clamped in neutral position (refer to Figure fl-4). adju ..t the rod ends of each nose gear steering rod to position the cockpit rudder pedals fore and aft. The centered angle of the rudder pedals is I) degrees aft of the vertical position (refer to Figure 6-5) with the airplane h~\ el. Place a bubble protractor against the pedal steering tube to check this angle. Do not attempt to make the adjustment by means of one rod end bearing. but divide t he adjustment between the bearings at each end of the steering. rod. A three-eighths inch minimum thread engagement must be held. Check by inserting a wire in the check hole of the rod.
If) Measure 10 degrees on each side of the chalk line. intersecting at the pivot point of the \\ heel. and check nose landing gear for 10 degrees maximum right and left travel. IsSt"EO: 8/18/72 1113 lA!'lDI~G GEAR AND BRAKE SYSTE'I 2170 '/ \/V "\ .~~J\ --. . -'1'111'---