BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMANCHE SERVICE MANUAL \ \ I J FIGURE &-8. INSTALLATION OF PLUMB 101 ATTACHMENT TOOL AND ALIGNMENT JIG 2. Jie Method: (Fabricate a jil and plwnb bob attachment tool COnfonnilll to specifications liven in Filum ~38 and 6-39.) (a) Attach a plumb to the plumb bob attachment tool aDd inall tool on the forward edp of the lower fll'e wall flange, or on the two nose gar baec tubes u shown in Pipre ~. (b) Attach alipitar jil to the rear of the Dose wbeelat the axle u shown in Fipre 6-6. (c) Ascertain that the a.irplane is laterally level. (Refer to LcveUn,. Section II.) (d) Tum the nOse wheel until the center liDe marked on me ji, a1ips with the plumb bob.

With the rudder pecbJs clamped in neuaal position (refer to Fipre H), adjust the rod encls of each nose gear steering rod to position the cockpit rudder pedals fore and aft. The center line of the rudder pedals is 13 degrees aft of the vcn:ical position (refer to Fipre 6-5) with the aizlliane level. Place a bubble prottaetor lpinst the pedal Stecrinl tube to check this aqie. 00 not attempt to make adjustments by means of one bearing but divide the adjustment between the rod end bearinp It each end of the rod. A tbree-ellhtbs inch mmimum mra-d enppment mUlt be held.

(e) Check nose gCat steerinJ for 20 dcpc maximum titht and left by turning the jig and wheel to the rilht and left while observinl that the ZO dqrec marits align witb tbe plumb bob. 6-17. NOR Gear Door A_mbly. (PA-Z.... t80, PA·2+-Z'O and PA-24-260, Setia.l Sos. 24-1 to 2~782 and 2+4i84 to 24--1-803 ind.) I. With the ,ear extended disconnect the nOK ,tar door retraction rod at tbe oleo strut by removing the eereer pin. washer. and pin. b. Remove the caner pin washer L'1d hinre pin from botb door hinges and remove door. 6-18. Removal Of Nose Gear Door A_mbly. LANDING GEAR AND BRAKE SYSTeM ISSUED: 8/18/72 1114