PIPER COMANCHE SERVICE MANJ.;Al f. Assemble the components of the piston tube (8) on the tube by placing. in order. the snap ring (. washer (28). lower bearing (24) with outer and inner "0" rings (26 and 25) and upper bearing (22). Align lock pin hole of the upper bearing with the pin holes in the tube and install pins (23). g. Lubricate the wall of the cylinder oleo housing (7) and piston tube (8). and carefully insert the tube assembly into the housing. guiding the orifice tube (19) into the piston tube until the snap ring (19) can be installed in the annular slot at the lower end of the housing. h. At the top of the housing. tighten the orifice tube locknut ( 12).
(Should it be an impossibility to tighten the locknut due to the orifice tube rotating with the nut. withdraw the piston tube assembly from the cylinder and. while tightening the nut. secure the orifice tube with the use of a I-I 2 x J 16 inch drag link socket held in the slot at its lower end. Check that the orifice tube is centered in the cylinder and then reinstall the piston tube assembly. i. Install the wiper strip (27). slide the washer (28) into position and secure the assembly with snap ring (29). j. Ascertain that the bushings are installed in the upper and lower torque links (5 and 2) and then install links.
~OTE Ascertain that the torque links are properly installed to insure complete travel of the piston tube and fork assembly within the oleo housing. The torque link bolt assemblies (6 and 10) should be lubricated and installed with the flat of the bolt head hex adjacent to the milled stop of the wide end of the link. (Use the same thickness of spacer w asher 1 J) between the two links as those removed to maintain correct wheel alignment.) Tighten the bolts only tight enough to allow no side play in the links. yet be free enough to rotate. k. Lubricate the gear assembly. (Refer to Lubrication Chart. Section II.) .' , I.
Compress and extend the strut several times to ascertain that the strut will operate freely and to links do not restrict travel in the compressed position. The weight ofthe gear wheel and forks should allow the strut to extend. m. Service the oleo strut with fluid and air. (Refer to Oleo Struts. Section 11.) n. Check the main gear alignment (refer to Paragraph 6-35) and gear operation. o. Remove the airplane from jacks. LANDIJlllG GEAR AND BRAKE SYS. REVISED: 4/10/81 1118