BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMANCHE SERVICE MANUAL FIGURE 8·1d. ADJUSTMENT OF MAIN LANDING GEAR DRAG LINK 6--34. AdjustmCftt Of MaiD Gar Stele Inn Links. (Refer to Fipte 6-10.) Disconncct the side brace link from the main gear saut bousing. and adjust to maintain a dilwlce of 6.1%5 inches betWeen the center of the pivot bolt which attaches the upper drq link to the lower drat link and the center of the rod end bearing. NOTE Do not check adjustment UM, bad of rod end bolt installed in StNt as bolt sets at an &nile to the center line of the lower drq link. 6·35. Alipmcnt Of Main Landini Gar. a. Place It. stniaht cdBe no less than twelve feet long aeross the front of both main landing gear wheels.

Bun the strailht edte apinst the tire at the bub level of the IaDdiftl gear wheels. Devise a support. or usc It. box. to hold the smifbt cdJe in this position. b. Set a square apinst the stru,ht edte and check to 1ft if its outsWldina ler bean on the front and rear sides of the main IandiJII pat tire. (Refer to Fipre 6·11.) If it couches both outboard sides of the tire. the landing gear is correctly aliped. The toeoin for the main landin, gear wheels is 0 dcgrccs. NOTE A carpenter's square. because of its crpecially long lep. is recommended for checking main landing ,ear wheel alipmc!1t. LANDING GEAR AND BRAKE SYSTEM ISSUED: 8/18/12 IJ6 ,.