BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMANCHE SERVICE MANUAL a. Position the ,cat door in place and secure with attaebinc screws. Maintain equal clarancc betwcen door and wing paael. ~38. InsraUaaon Of Main LaadiD, Gar Door A.mbly. b. Connect the retr.u:tion rod to the oleo strue wim artachiDI bolt. wuber aDd nut. 6-39. Adjumnmt Of Main LaadiDI Gar Doon. a. Ascertain that there is an all around even c1an.Dc:e between the door and wiDt panel when the door is in the mracted position. b. Adjust by loosenifts the door binfe screws in me wiaJ paad. rqKIIitionm, the door and retiJhtening the screws. c.

The ,CI.t door aCNatiDI rods should be adjuaed 10 that a Dine pound weilbt suspended at the center line of the inboard tdJe of the door in the rctneted pOlition will crace a O.US of an inch deflection from the wing contour at the inboard edp of the door. a. Place the airplane on jacks. (Refer to Jac:IciDI. 5eetiollll.) b. lacx the airplane only hiJh CDO"Ib to take wcipe off the pat. c. Releue the air p~ from the strut by deprasm; the Ґ11ft core pin until the pressure has diminished. 6-40. Replacement Of Wipe Scrip On LlDdin, Gar Saua. d. Using snap "III pliers.

dianpce the snap rint from the UIIlWar sloe in the oleo housm, and allow it to lay at the lower end of the piston tube al0l'll with the Wiper strip retainer WIlber. e. Remove the old wiper strip from the housinC. and c1aD and iDspcn the housinl to determine that no pieces remain in it, f. Wipe the piston cube and check it for any abrasions which may damar the raew wiper. Polish the rube to remove any abrasions found. g. A new wiper strip should be CUt strailht acroUt and a linle loftier than needed. to circle the piston cube. b. Insert the new wiper strip up intO the oleo housinJ with the tapered cdte down.

Slide the retainer washer and snap ring up the piston Nbc and inxn them into the oleo hOUlinJ. Usine map ring pliers to compress the map ring. insull it into the annular slot in the oico bousina. i. Inflate the oleo smlt ill accordance with instructions Jiven ill Oleo Scnaa, Section 11. and remove the airplane from the jacks. LANDING GEAR AND BRAKE SYSTEM ISSUED: 8/18/72 IJ8