PIPER COMANCHE SERVICE MANUAL FIGURE 6-15. NOSE GEAR DRAG UNK CLEVIS c. Turn the transmission release tube (19) on aCN,cor screw to maintain a distance of 10.875 inches between the center of the mnsrniaion mounOnI pin (12) and center of the thru bolt (13) connecting the lower portion of the torque arms. This Idjusanent should allow approximately a (minimum of 0.125 inch) measured alo", the aenaator screw (14) between the ron pin ItOp (16) and the screw nut 0'). d. The cable rods (5 and 6) should be moved to .pproximately 1/8 inch of bci", f1.JU aft.
e.' Adjust the push-pull rod ends (7 and 8) to &1low their connce:tinJ pins (17) to push freely through the torque arm clevises (9 and 10) and rod end bannp. f. Check that the threads of the push-pull cable rods extend put the chcdt holes in the rod end fittings. secure the rod end lim,. jam nuts and safety aU pins. g. Safety wire all cude nuts u shown in Filure ~14. Sketch A. Airc:nft which have lock wahers should be safety wired in accordance with Fiprc 6-14. Sketdl A. ~'5. Adjustment Of MaiD Gar Push-Pull Cables. a. With the ausmission uscmbly adjultCd (refer to p ......
ph ~54) and the cnr down and locked, adjust the push-pull cablc rod end so the banna bole &lip with the hole in the cine link. b. Extend the rod end fiaina one haJf nam OD aD old cable ud one complete tum on a new cable. This will provide the necessary preload to absorb backlash or play in the cable. Also, it will produce a small amount of conswu pressure. thtoqh the cable &pinK the par link when the sear is down and locked. c. Be. sure the thresds of the push"Pull cable extend pused the check hole in the rod end fitting. Tighten the jam nut apinst the ted end Gainl and install wist SPrint. IJ18 LANDING GEAR AND BRAKE SYSTEM REVISED: 6/25,16