BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMANCHE SERVICE MANUAL "232 3 I. T.OVC All .. &a,T. a. " T .. IIIT leu. J. I. T 1.'TeN I.'''''T 'W'TeN .tott .... FIGURE &018. LANDING GEAR UP LIMIT SWITCH 6-56. Adjumnent Of No. G ... PuIb~ Rod. a. Atw:h the mraction rod cicY1J to the left note par dnt link. Shims are installed between the clevis and drq Link for correct retraction of the nose par :nco the wheel weill. Two metbo~ of attaclUMnt of the clevis to the Link have bem used. b. Oft early PA·Z4-180 aDd PA-Z ....Z50 airplanes. the clevis bas a threaded stud which is screwed intO the link assembly (mer to Fipre 6-15.) A minimum of 1/8 inch and a maximum of 3/8 inch of shims may be iDsWled.

Shims arc supplied in sizes of .01 0.3Z. 0.64 and .125. The c:Jcvis torque must be from 13 to 40 foot pounds. property alianed. with the countcr-sunk .hole side of the .064 ud .125shimupiastthe radius of the clevis stud. c. On late PA·Z....180 and PA-Z4-Z'50. and all PA·Z....Z60 and PA·Z4-0400 airplanes. the cleW has a lock-inK nut applied to the threaded ponion of the clevis stUd (refer to Fipre 6~15). Shims supplied Wlth this clevis are .032 only and a maximum of three may be insca11ed. d. With the main and nose ,ear down and lodted. adjust the push.,ull rod end fittinl until the hole in the rod cnd bcarina alians with the bole in the clC'ris. then cum the rod end in one complete cum.

For proper clearance of the clevis. install the clevis bolt with the countenunk ponion at the left or outboard side. LANDING GEAR AND BRAKE SYSTEM ISSUED: 81l1nZ IJ19