BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMANCHE SERVICE MANtAL ~OTE With the gear in the full retracted position. check for interference at the push-pull rod and clevis. The locknut at the rod end bearing rnav bind with the clevis and cause failure at the threaded portion of the end bearing. The rod end threads should be carefully examined for cracks. When checking the landing gear for operation on jacks. disconnect the retraction transmission and nose gear down lock springs. Following adjustment to any of the three gears in which the control tubes rod were disconnected with aircraft on jacks. the transmission disconnected.

ascertain that all three gear drag links go over center and lock at the same time independently of each other. e. Check nose gear door adjustment. (Refer to Paragraphs 6--17 and 6-22.) a. Adjust the gear up switch using the following procedure: I. Retract the gear and check to insure that both main gear assemblies enter the" heel well approximately the same distance and that the nose gear enters far enough. (Refer to Figure 6-16.) 6--57. Adjustment Of Gear L'p Switch. , If the gear does not retract far enough. move the switch (3) up in its bracket and run the check again. On the late model airplanes. a set sere" (2) is located in the left torque arm (I) for fine adjustment purposes.

J If the gear retracts too far before the motor shuts off. the switch must be moved dow n in its bracket. 4. To determine a proper fit of the main gear. retract the landing gear. The main gear ShOUld. pulled snugly against the rubber stop blocks located in the wheel well. and the nose gear should fully retr 5. Should it be found necessary to adjust the nose gear. remove or add shims at the drag lir clevis. then readjust the push-pull rod. (Refer to Paragraph 6-56.) 6. Check nose gear and main gear door adjustment. 7. Check for proper adjustment by operating the gear and that the manual retraction handle is free of obstruction which could cause binding. REVISED:

4/10/81 IJ20 LANDING GEAR AND BRAKE SYST.