BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMANCHE SERVICE MANUAL "'-'--z I 'Ul :)II~ I U:~ .. ",~, FIGURE 1-31. REPLACING BRAKE DISC d. Slide the brake disc (-4) on the wheel and poaUoft the cyliDder housing apinst the disc. e. Se~ the cylinder housint to the torque plate with the 3 cap bola (15) ud safety. Ј. Connect the brake litIe co the brake cylinder hOusiq. ,. Bleed the brake system as described in pananph 6-88. NOTE The fint three or four brake applications. aner brake reliJUnl. should be moderate to allow the resins in the lininl co bum out slowly. The burninl out or resins is also the determine factor in the uscfullife of the brake Iininl ud if hiJh speed stOps are avoided.

whenever possible, brake linint Life and brake pcrfol"D1&ftCe will be considerably improved. 6-87. Replacement Of Wheel Bake Dile. (C1evdInd)(Rcfcr to Fipre 6--31.) Riveted Brake Disc. a. Remove eight rivees amchinJ brake discs to inner wheel half by chiseling off heads inside drum and punchllll them out. b. Place wheel half assembly intO boilinc water for' minutes and remove disc from wheel casting by usc of pry bats. c. Clean cutin! thoroughly and apply heavy coat of zinc chromate paint in brake disc recess. d. Place whecl castinl into boiling water for a few minutes. remove and insert ncw replacement brake disc into the expanded wheel.

Ascertain that brake disc is property seated in recess in wheel half. e. Clamp wheel half ud bRke disc assembly in vile and locate ciCht 3/16 in~ drill. dnJl through disc with an 11l6~ inch drill. and then re-drill with a 3/16 inch drill. LANDING GEAR AND BRAKE SYSTEM ISSUED: 8/18/72 lK16 Ј. Rivet whccl half to brake disc with eiplt AN~2' AD6-7 rivets. Sec riveE from both ends EO be cerum rivet has properly filled the hole and file rivet heads flush with tire scat and paint.