PIPER COMANCHE SERVICE MANUAL ":::a.==== FROM PRESSURE POT FIGURE 8-32. BLEEDING BRAKES Non Riveted Brake Disc. a. Place wheel half assembly into boiti", water for 5 minuteS and mnove disc from wheel casting by use of j)ry ban. b. Clean CUlm, thoroUfhly and apply heavy coat of zinc chromate paiDt in brake disc rece c. Place wheel castinJ into boiling water for a few minuteS, mnove and insert new replacement brake disc into the expanded wheel. Ascertain that bolt holes are IiJncd and brake disc is properly seated. ~88. Bleeding Procedure. (Refer to Fipre 6-32.) If the brake line has been disconnected for any reason, it will be necessary to bleed the brake and line as described below. a.
Place a suitable container at the brake raeriOir to collect fluid overflow. b. Remove the rubber bleeder fitting cap located on the bottom of the brake unit housing on the landing gear. c. Slide a hose over the bleeder fitting, loosen the fimn, one tum &Dei pressure fill the brake system with .\tlL·H-S606 fluid. NOTE By watching the fluid pI» through the plastic hose at the top of the brake reservoir, it can be determined whether any air has entered the system. If air bubbles are evident, rlllinJ of the sysmn shall be continued until all of the air is out of the system and Ii steady flow of fluid is obtained. d. Tighten bleeder fitting and remove the hose.
Check brakes for proper pedal pressure. e. Repeat this procedure on the other gear. f. Drain excess fluid from reservoir to Fluid Level line with a synnlC. LANDING GEAR AND BRAKE SYSTEM REVISED: 4/10/81 lK17