BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMANCHE SERVICE MANUAL Exaggerated view of nicks in leading edge. &aggerated view of nick in face of blade. A Aecommended method for re- moving nicks by riffle file and crocus cloth. Blend deepest ponion of nick into leading edge align- ment with smooth curves. SECTION AA- Nick in face of blade removed by file and crocus Cloth as recommended. FIGURE 7-2. TYPICAL NICKS AND REMOVAL METHOD 7-10. Cleaning. Inspection And Repair Of Propeller. a. Check for oil and grease leaks. b. Clean the spinner. propeller hub interior and exterior. and blades with a noncorrosive solvent. c. Inspect the hub parts for cracks. d. Steel hub parts should not be permitted to rust.

Use aluminum paint to toueh up if necessary. or replate during overhaul. e. Check all visible parts for wear and safety. f. Check blades to determine whether they tum freely on the hub pivot tube. This can be done by rocking the blades back and forth through the slight freedom allowed by the pitch change mechanism. If they appear tight and are properly lubricated, the propeller. should be disassembled by an authorized service center. g. Inspect blades for damage or cracks. Nicks in leading edges of blades should be filed out and all edges rounded. as cracks sometimes start from such places. Use fine emery cloth for finishing. Refer to Figure 7-2 for propeller blade care. h.

It is recommended that for severe damage. internal repairs and replacement of parts. the propeller should be referred to the manufacturer or Certified Repair Station. i. Grease blade hub through zerk fittings (Hartzell propeller only). Remove one of the tWO fittings for each propeller blade. alternate the next time. Apply grease through the zerk fitting until fresh grease appears at the fitting hole of the removed fitting. Care should be taken to avoid blowing out hub gaskets. ISSUED: 8/18/72 2A15 POWER PLAt