PIPER COMANCHE SERVICE MANUAL i·l1. Installation Of Propeller. (McCau.lcy) (Refer to FiJure 7·1.) CAUTION A~crtain the .\taster Switch and Mqneto Switch ue ill the "OFF" position and the Mixture Conttol is in the "IDLE CUT.()FF" polition. a. POlition the spinner bulkhead rina (5) apimt the starter riDt leu support (4) 10 thac one arrow lina up wim the TCI. OQ the front face of the suppon:. b. Secun: the spinner bulkhead to me stifter rina par mppon: with 12 bola (U. 12 nuts (3), and 201- wuben (2) (one under the bolt head lAd one IlDder each Qut). Cuefully tipten QUts Ilftifonniy to torque limits shown in Table VIJ-1. c. Clean the propeller and eftline tlanps. d.
Observe the starter rina par co make sure it is mounted properly on the eftIine crankshaft fianle. The cnnkshaft flange is stamped with an "0" mark and the Rafte: rinJ leu is likewise identified by an "0" mark. Upon insullation of the Slarter riat par. the ma.rltiDI shall be mated to insure proper installation. e. Insert the "0" rinJ (6) in the pove of the propeller hub bon:. Make Sllft that the "0" rin, is not twisted and is liberally coated with clan lubric:atiq oil. NOTE Some McCauley Model 2D36C14 propcUcrs will be founei in use with a. counterbon: in the hub instead of an "0" rial pave. When uutallitlc tilese propellers. always insen:
the "0" rinJ in the counterbore and push it to the bottom. Sever slide the "0" ring on the c:n.nkshaft pilot. f. Raise the propeller and line up the mows on the hub flanae outer diameter with the short bushing in the crankshaft n&nfe. En..,e the pilot in the hub. making sure that face of hub f1anIe is puailel wlth the face of the cranksnaft flange. then push the propeller in. Make sure that the bolt holes eDBace the bushings. CAUTION It is important that the propeller be seated &pin. the crankshaft flanae with a stTallht push. Rotating or cockinl it on will c:aUJe damage to the "0" rinJ and oillcaka.Jc will result.
Particular cue muSt be taken while installing hubs haviftl a ecunrerbore co prevent damapnl the "0" ring or displaclDB it so that it is lodged betwccn the flange faces. The latter condition will be indicated by nofttn.cking of the blades immediately after insullation. POWER PLANT ISSUED: 8/18/72 2 AlB