BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMA!'lCHE SERVICE MASl'AL g. Slide washers (9) on bolts (~) and tighten bolts uniformly all around to the torque limits of Ta. VII-I and safetx wire bolt". h. Check blade track. (Refer to paragraph 7-15.) h. Slide spinner (10) O'er the propeller. align screw holes with the nuts in the bulkhead. and 10 ... 1,,11 washers (12) and screw" (Ill. Tighten to the torque given in Table Vl l-I. 7-12. Remon) of Propeller. (Hartzell) (Refer to Figure 7-3.) ~OTE In some manner identify the position of each part in relation to the other to facilitate installation. a. A..certain that the master switch and magneto switches are in the off position. b.

Remove the spinner (I) by removing the screws that secure it to the spinner bulkhead (4). c. Place a drip pan under the propeller to catch oil spillage. d. Cut the safety wire around the propeller mounting bolts (8) and remove the bolts from the engine crankshaft flange. e. Pull the propeller from the engine crankshaft. f. Remme the propeller "0" ring (10) and shim (I \) from the engine flange. g. The spinner bulkhead may be removed from the starter ring gear (5) by removing nuts. wa ... her ... and bolts It.). i_I J Cleaning. Inspection And Repair, The instructions for cleaning. inspection and repair of the Hartzell propeller are the same as tho ... I.' gi,.

for the ~1cCauley propeller paragraph 7-10. 7-14. Installation Of Propeller. (Hanzell) (Refer to Figure 7-3.) a. Position the spinner bulkhead (4) against the starter ring gear support (5) so that one arrow lines up \\ ith the Te I. on the front face of the support. b. Secure the spinner bulkhead to the starter ring gear support with 12 bolts (6). 12 nuts (91. and 24 washers (J) (one under the bolt head and one under each nut). Carefully tighten nuts uniformly to torque limits shown in Table \'11-1. c. Clean the propeller and engine flanges. d. Observe the starter ring gear to make sure it is mounted properly on the engine crankshaft flange.

The crankshaft flange is stamped with an "0" mark and the starter ring gear is likewise identified b~ an ·'0" mark. L'pon installation of the starter ring gear. the markings shall be mated to insure proper installation. e. Install "0" ring (10) and shim (II) on engine shaft. ISSt'ED: 8/18/72 2A17 POWER PL.\".