PIPER COMANCHE SERVice MANUAL Disconnect the carburetor heat control caDle from the air box. Disconnect the carburetor heat air duet from the air box. Disconnect fuel line from carburetor. Remove carburetor from the cJlline sump by remOYinJ pallock nuts and wuhen. Cut safety wire and remOve bola atuchq the air box to the carburetor. c. d. e. f. g. a. Secure an box with plket to the carburetor uu, cap bola and washers. Saiety with lock wire. b. Install pskct and CU'buretor on the bottom of the sump &Del ICcure with washcn. nuts and pal locknuts. c. Connect fuel line to carburetOr. J. Connect throme. mixnlrc and carburetor but conuol cables to carburetor and air box.
and adjust per paragraph 7·36. 7·35. InsuUation Of CarburetOr. c. Connect carburetor heat air duct to air box. ;-36. AdjUItJIICftt Of ClrburnGr Controls. (Refer to Fipre 7-6a.) The throttle mixture and carburetor helt connols are adjusted so that when the throttle arm on the carburetor is rotated forward apinst iu full throme stop and the mixture Irm is rotated forward qainst its ruU rich stOp and the carburetor heat arm is rotated to the fuU ram air position. their respective cockpit controls should be .062 of an inch out from their fuU forward stops. a. Disconnect the throttle cClfttrOl cable at the carburetor and loosen the jam nut securing the cable end. b.
AdjuSt the linkage by rotating the cable end to obtain the .062 of an inch spring back of the cockpit control when the throttle arm contacts its Stop. c. Reconnect the cable end to the control ann and secure jam nut. Ah, ~55::s~~j~"--- PAN EL ASSY. SPRING- BACK .0625 FIGURE 7-6 COCKPIT CONTROL SPRING BACK POWER PLANT ISSUED: 8/18/72 2 85