PIPER COMANCHE SERVICE MANUAL 1 ~--. ~_-5 ::::1---- 4 .,.:....tIw-'~ 2 I. IDI.' MlllT\,IR, "DN'TM'''T Z. M'IlT\,III' COIITROI. ..III" J _1. DIII ... 10 "\,111. IIII.IT 'C" .... S. TIOIIIOTTl.1 All .. t. 101.1 6OJ\j,T .. , .. T 7 ...... "T IClIlW FIGURE 7·7. CARBURETOR d. Adjust mixture and carburetor heat control by loosening the cutelled nut at the control anns and sliding control cable throulh the stud until the .062 of an inch spril'll back of the cock!,it control is obtained when the mixture is in the full rich position and the carburetor heat is in the full ram air position. e Tighten casteUed nut and safety. f. Pull the throttle.
mixture and carbureror heat controls in the cockpit full aft to as that the thrcrtle um contactS the idle screw and the mixture control arm contaet1 its idle CUt off StOP and the carburetor neat flap valve is in the full carburetor hut position. 7-37. Adjusanent Of Idle Speed And Mixture. a. Start the engine and wann up in the usual manner until oil and cylindcr head temperaturcs are normal. b. Check lrl.lJftCtos. If the "mq-drop" is normal. proceed with idle adjusanent. c. Close the throttle to idlc. If the RPM chanps 'Jlpreciably aiter makinl the idle mixture adjustment durina the succeeding steps. l'ftdJusc the idle speed to the desired RPM.
NOTE The idle mixture must be adjusted with the fuel boost pump "ON". POWER PLANT ISSUED: 8/18/72 2 86