BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER CO\1ASCHE SERVICE MASl:AL 9 11. RIVETS 12 LEAD CIRCUIT 13 CONTACT SPRING 14 INSULATOR 15 VENT PLUG i. Inspect impulse coupling 121 magneto) flyweights for excessive looseness of the axles. Design couplings having .917 inch thick body should be checked with I 8 inch drill. Couplings \\ ith .974 inch thick body are checked" ith a \0. I R drill. If drill fits between cam and flyweight the fit is too loose and coupling should be replaced. (Refer to Figure 7-10.) j. Check impulse coupling for excess wear on the contact edges of body and flyweights. k. Check that the impulse coupling flyweight axle rivets are tight and there are no cracks in body. I.

Check lead conduits for frayed or broken areas of braid due to excessive wear and replace where deemed necessary. 1 CONTACT SPRING 2 RETAINING SPRING 3 DISTRIBUTOR BLOCK 4 BREAKER COMPARTMENT 5 LEAD WIRE 6 CAPACITOR 7 BREAKER ASSEMBLY 8 BREAKER CAM 9 IMPULSE COUPLING 10 FLYWEIGHTS FIGl'RE 7·8, MAGNETO INSPECTION m. Check the springs for breaks. corrosion, or deformation. If possible. check continuity from block with tester or light. n. Check insulators for cracks. breaks or deterioration due to age. Ascertain insulators are clean. o. Timing and ventilator plugs. Ventilator has drilled holes and should be in lowest hole in magneto to sene also as drain for excess water or oil.

Solid plug is used in other hole - or in location exposed to rain or water. !'OTE The magneto service instructions in this manual are to cover minor repairs and timing. For further repairs and adjustments of the magnetos. it is recommended that the manufacturer's service instructions be followed. 2B8 POWER PLA~T REVISED: 4/10/81