PIPER COMANCHE SERVICE MANUAL FIGURE 7-9. LEAD POSITIONING FIGURE 7.. tO. IMPULSE COUPLING 7-41. Removal Of Magneto. a. lift the side panels of the engine cowling. b. Disconnect the "P" lead from the magneto and the retard breaker lead from the left. -200 series. magneto. c. d. Remove the harness outlet plate from the magneto by removing the four attaching screws. Remove the two nuts and washers securing the magneto to the engine accessory housing. Pull the magneto from the engine. e. 7.42. Timing Procedure. (Internal Timing) -20 and -200 series magneto main breaker points. When installing new or adjusting breaker points and before timing the magneto the engine.
it is important that the internal timing of the magneto be correct. a. To internally time the magneto it should be removed from the engine to determine "EO gap. b. To determine "E" gap. find neutral position of the magneto drive by rotating drive coupling in a left hand direction until the red or white chamfered tooth on the distributor drive gear appears through the timing inspection hole. At the same location. the drive should feel to have fallen into a notch or neutral position. c. Rotate coupling from neutral. in a left hand direction 100. appearing through timing hole. when the white or red tooth aligns with the white line of the distributor block. the magneto is set at "EO gap.
(Refer to Figure 7-11.) Alignment may not vary over +4°. d. Using the alignment of the chamfered tooth on the distributor gear and the white line of the distributor block as a reference. adjust the breaker points to open at this point. Turn the magneto drive until the cam follower is on high point of the cam lobe. Measure contact clearance. it must be .018 inch + .006 with the point opening set at "E" gap + 4°. If breaker points do not come within tolera.nees. they should be replaced. ISSl'ED: 8/18/72 2B9 POWER PLANT ~FT ~CTATION MEASURE BODY THICKNESS HERE