BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMANCHE SERVICE MANUAL TIMING MARK FIGURE 7·15. ENGINE TIMING MARKS 7-44. Installation And TimiDJ Procedure. (TiJhinl Maplcto to Enpe.) The mlJnetos can be installed and nmed to the enatne by the foUowinl procedure; NOTE Ascertain that the breaken are .:orrect for proper internal timing of magnetos. a. Lift the et\!lne cowling side panels. b. Remove the tOP spark pll.ll from ~o. one cylinder. Place the thumb of one hand over the spark plug hole and rotate the crankshaft in direction of nonnal rotation until the comprc5,1ion srroke IS reached. The compression stroke is indicated by a positive pressure inside the cylinder tending to lift the thumb cif the spark plug hole.

In this posinen both valves of No, one l:)'linder ate dosed. Turn the crankshait opposite to its normal direction of rotation until it is approximately 35 degrees BTe on the compressicn stroke of No. one cylinder. Rotate the crank.maft in its normal direction of rOtation until the 25 degrees mark on the back of the starter gear and the crankcase panUlg sutiaee are aligned. or the marks on the front of the starter rinl gear and the drilled hole in the starter housing align. (Refer to Figure i-I 5.) NOTE The impulse coupling magneto l-21) or the ·ZOO shower of sparks magneto can be used only on the left side of the engtne I a.s viewed from the rear). POWER PLANT REVISED: 4/10/81 2 812