BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMANCHE SERVICE MANUAL c. Rotate the drive gear on the mapeto until the c:hamfered tooth on the distributor ,car inside the magneto alians with the white pointer u sam throu,h the inspection hole in the magnetO housin,. d. WithOut allowing the feat to tum from this position, insull the mqneto with psket on the engine ana secure with wuher! and nutS. e. Tiabten nuts sufficiently to bold mapeto in position and yet allow it to be route(l. f. Futen the ground lead of the timing I.iJbt to an unpainted dleW1ic portion of the ma«neto and one posltive lead to the terminal side of the main breaker peina. g. Turn on the timqUcht switch. h.

Route the mapcto housin, in the direction of the maplet rotation a few dqrccs until the timiftl light comes on. Then slowly Nm the maplecc in oppositc direction until the timinlliJht just goes out. Secure the mapcto housing in this position. NOTE Some timing lights operatc the OPPosite of the one mcntioned. i. Route the cnnkshaft opposite DOnna! roution until it is approximately 3' degrees BTC on compresslon scroke :-.10. one cylinder.

NOTE The c:rwshait should not be routed more than 10 dqrccs in direction opposite normal roeation from thc 25 dqrce aTe as the pawl on the impulse coupling (·21 m*lftetos) will enpp with the stOp pin and late timint will be indicated throUJh the impulse coupq mcch&n.ism. If this should happen. route c:rankshaft in 1lOrm&i direction until sharp click is heard. this will indicate that the impulse coupliq bu pused through firinl position. Tum crankshaft in direction oppositc normal roution to approximately 35 degrees BTCand proceed with timiDI check. j.

Turn the cn.nkshait very slowly in direction of 1l0rmal rotation unQl the timing mark on the front face of the ring gear a.1igns with the drilled hole in the starter or the timing mark on the back of the ring ,eu alignswith the crankcase pU'tinJ surfaca. At this point the liIht sbould '0 eue, k. If the light does not go eue at this point. alien timing marks and route magneto on mountiftl flange in the desired dirtttion and repeat the proceduR until the light goes OUt at 2S degrees before top dead center. CAUTION When timing retard breaker magnetos to the engine. only main breaker pOints arc timed. :-.lever attcrnpt to time retard breaker points to the engine. POWER PLANT ISSUED:

8/18172 2 813