BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMANCHE SERViCE MANUAL 7-52. Inst11lacion Of Sp.k Plup. Before iftstallinc spm plup. ascmaiD that the thrads within tile cylinder are clean and not dunlfed. a. Apply anti-seize compound sparinliY on the threads and iDaall psKct and spark plup. Torque 360 to 4020 inch pounds. CAllTJON Make certain the deep socket is properly seated on the spark plUl hexacon u clamaae to the plUl could result if the wrench is cocked to one side when pressure is applied. b. Carefully insert the terminal insulator in the spark plUl and tithten the couplin'IlUt. 7-53. Lubricacion Systelil. 7-54. Oil Prcuure Relief Valve.

Subject mpnes may be equipped with either an adjusuble or non-adjustable oil pressure relief valve. A brief description of both types foUows: a. NOll-adjustable Oil Preuun: Relief Va1ve· The valw is not adjlllt&ble: however. the pressure can be conaolled by the addition of a maximum of three STD~25 washen under the cap to increase pressure or the use of a spacer (Lycominl PIN 73629 or 73630) to deereue pfCSIW'C. Panicles of meaJ or other foreign matter lodged between the ball &nd scat will result in a drop in oil prasure. It is advisable. therefore. to disassemble. inspect. and dean the valve if excessive preaure fluCN&tions are ROted.

The oil preSlUre relief valve is not to be mistaken for the oil cooler by·pus valve. whote function is to permit pressure oil to by-pus the oil cooler in case of an obm'\lction. b. Adjustable Oil Pressure Relief Valve - The adjustable oil prasure relief valve enables the operator to maintain en,ine oil prasure within the specifacd limits (refer to the ape manufacturer's &ppropriate manllll). The valve is loc&ted &bove and to the rear of No.3 cylinder. If the pressure under normal operatins conditions should consistently exceed 90 psi.• or run less than 60 psi.. adjust the valve as follows: With the engine thorouply warmed up and runninl lot &maximum of 2200 RPM.

observe the reading on [he oil pressure lauge. If the pressure is above 90 psi. StOP eqine.loosen the adjustin,locknut; &nd back off the adjustina scrcw one or twO fun turns. Tiabten locknut and retest. If prcuure is tOO low, tum &djusting screw funher into the rdief valve plua. thereby iDcreuinl the tension on the relief valve spnng. When the valve has been satisfactorily adjusted. tilhten the 10c1u:aut and lock wire the crown nut to the drilled eu projecting from the valve mountlftl boSi. 7·55. Oil Screens. The oil screens are the pressure screen. located in a dome shaped housing. above and between [he magncros and the suction screen located in the lower Ut section of the sump.

These screens should be cleaned at each oil chanae to remove any accumulation of sludp and to e:tamine for meui filings or chips. If meral particles are found in the oil screens. the eftlPne should be examined for internal da.rnage. POWER PLANT ISSUED: 8/18/72 2 818