PIPER COMA~CH[ SERVICE MA!I'll:AL 74A-14. Installation Of Propeller. (McCaule)') (PA-24-250) (Refer to Figure 7A-I.) CAL'TIO' Ascertain the Master S\\ itch and Magneto Switch are in the"OFF" poxitinn and the Mixture Control is in the "IDLE-CL'T-OFF' position. a. Position the spinner bulkhead ring (5) against the starter ring gear support (4) so that one arrow lines up with the TC I on the front face of the support. b. Secure the spinner bulkhead to the starter ring gear support with 12 bolts (I). 12 nuts (3). and 24 washers (2) (one under the bolt head and one under each nut). Carefully tighten nuts uniformly to torque limits shown in Table \'IIA·1. c. Clean the propeller and engine flanges.
d. Observe the starter ring gear to make sure it is mounted properly on the engine crankshaft flange. The crankshaft flange is stamped with "0" mark and the starter ring gear is likewise identified by an "0" mark. L'pon installation of the starter ring gear. the markings shall be mated to insure proper installation. e. Insert the "0" ring in the groove of the prope\1er (7) hub bore. Make sure that the "0" ring is not twisted and is liberally coated with clean lubricating oil. ~OTE Some \1cCauley Model 2036CI4 propellers will be found in use with a counterbore in the hub instead of an "0" ring groove. When installing these propellers.
always insert the "0" ring in the counterbore and push it to the bottom. Never slide the "0" ring on the crankshaft pilot. f. Raise the propeller and line up the arrows on the hub flange outer diameter with the short bushing in the crankshaft flange. Engage the pilot in the hub. making sure that face of hub flange is parallel with the face of the crankshaft flange. then push the propeller in. Make sure that the bolt holes engage the bushings. CACTIO' It is important that the propeller be seated against the crankshaft flange with a straight push. Rotating or cocking it on will cause damage to the "0" ring and oil leakage will result.
Particular care must be taken while installing hubs having a counterbore to prevent damaging the "0" ring or displacing it so that it is lodged between the flange faces. The latter condition will be indicated by non- tracking of the blades immediately after installation. '\'IIA~I and safety wire bolts. g. Slide washers (9) on bolts (8) and tighten bolts uniformly all around to the torque limits of Table h. Check blade track. (Refer to paragraph 7A-22.) i. Slide spinner (10) over the propeller. align screw holes with the nuts in the bulkhead. and install washers (12) and screws (\ I). Tighten to the torque given in Table VilA-I. ISSt-ED: 8/18/72 2C9 POWER PLA'T