PIPER COMANCHE SERVICE MANUAL FIGURE 7A,,2. TYPICAL NICKS AND REMOVAL METHOD 7A-13. Cleaning, Inspection and I\.epair Of Propeller. (Refer to Figure 7A-2.) a. Check for oil and grease leaks. b. Clean the spinner. propeller hub interior and exterior. and blades with a non-corrosive solvent. c. Inspect the hub parts for cracks. d. Steel hub parts should not be permitted to rust. Use aluminum paint to touch up. if necessary. or replace during overhaul. e. Check all visible parts for wear and safety. f. Check blades to determine whether they turn freely on the hub pivot tube.
This can be done by rocking the counterweights or blades back and forth through the slight freedom allowed by the pitch change mechanism. lfthey appear tight and are properly lubricated. the propeller should be disassembled by an authorized Service Center. g. Inspect blades for damage or cracks. Nicks in leading edges of blades should be filed out and all edges rounded. as cracks sometimes start from such places. Use fine emery cloth for finishing. h. It is recommended that for severe damage. internal repairs and replacement of parts. the propeller should be referred to the Manufacturer or Certified Repair Station. i. Grease blade hub through zerk fitting (Hartzell propeller only).
Remove one of the two fittings for each propeller blade. alternate the next time. Apply grease through the zerk fitting until fresh. grease appears at the fitting hole of the removed fitting. Care should be taken to avoid blowing out hub gaskets . ISSUED: 8/18/72 2C8 POWER PLANT Ellaggerated view of nIcks In Eqggerated view of nIck leading edge, In face of blade, Recommended method for re- moving nIcks by riffle file and SECTION AA- crocus cloth. Blend deepest panion Nick In face of blade removed of nIck into leading edge align- by file anrt crocus cloth as ment with SmOOth curves rec:ommended