PIPER COMANCHE SERVICE MANUAL 4 2 f 5 e 10 9 1.IOL.T 2. I"L.AIN WASHER 3. SELF·LOClCINO NUT 4. STMTtfll RING GEAJIl SUPPORT I. SPINNER ADAPTOR RING e. "0" filiNG SEAL 7. PROI'ELLER e. HUI MOUNTING 10L.T e. WASHER 10. SPINNER 11. TAUSS HEAD SCREW 12. FIlER WASHER 8 12 FIGURE 7A·1. PROPELLER INSTALLATION (MCCAULEY) PA·24-2S0 7 A-12. Remov&l Of Propeller. (McCauley) (PA·2.Z50) (Refer to Piture 7A-1 ) NOTE In some manner identify the position of each put in relation to the other to facilitate installation. a. Remove the spinner (10) by removing the screws (11) that secure it to the spinner buJkhcad (S). b. Place a drip pan under the propeller to catch oil spillage. c.
Cut the safety wire around the propeller mountinJ bola (8) and remove the bolts from the cftllnc crankshait Hanie. d. Pull the propeller from the en,ine cnnkshafr. e. Remove the propeller "0" ring (6) from the propeller hub bore. i. The spinner bulkhead (~) may be removed from the starter nng gear (~) by removIng nuts, washers and bolts. POWE~ PlANT ISSUED: 8/18/72 2 C7