PIPER COMANCHE SERVICE MAN'UAL 1QOaX -n 'i-i r, '~IIOIOU Z. NO"'I. .. III'LAOI ~. LOW ~ITC:" .. DJII,T"IIOT t. 1.0CII "liT S. ''''A'I ~'TTI'" IOIIT 7. ITIIO 1I0L~ "" ,. t·O,t1 Ill'''. II,&L IQ. "'1010.11 ..D ·OII ~I". 1I M'"' .,. TIII II". FIGURE 7A-4. PROPELLER INSTALLATION (HARTZELL) PA·Z4-2IO 7A·19. C1cUlinC,IDlpfttioQ ADd R.epair. The instrUctions for c:lcaninJ. inspection and repair of the PA·24--260 Hartzell propeller an the same is those given for the .'Ґtc:CauJey propcll~ used on the PA·24-250. (Refer to p&nIBph 7A·l3.) a. Clean propeller and enpe fiances. b. install spinn~ bWkhead (10) on start~ rinC acar (11) and torque bolts to spec:ificationsgiven in Table VilA-I. c.
Observe the starter ring gear to make Nrc it is mounted properly on the engine crankshaft flange. The crankshrlt t1ange is stamped with an "0" mark and the scarter ring gear is likewise identified by an 7 A·20. Inscallation Of Propeller. (PA·24-260) (ader to FiJUM 1 A~.) "0" mark. Upon installation of thc starter ring gear. the markings shall be matcd to insure proper installation. . d. Lubrieate and install O-ring (9) in thc propeller hub O-ring lJfoove. POWER PLANT ISSUED: 8/18/72 2 C12