PIPER COMANCHE SERVICE MANUAL e. ."ount propeller on engine. Screw each stud (7) intO its matinl f1&n~ bushill, I few threads at I time until all are tight. Torque bola to specifications given in Table VllA·1. SafetY the mounting bola with ."S20995C"1 wire. routing the wire through the lock pills (8). f. Check blade track per p&rllf&ph 7 A-22. g. Check low pitch blade &nile. (Refer to parqraph 7A·Zl.) h. Install engine cowling if removed. I. Install spinner (1) and secure with screws. 7A-2L Adjustment Of Low Pitch BI.x ADtlc Stop. I. The propeUcr comes from the factory with the low pitch stOp adjusted for proper blade angle. If. however. this adjustment has bccn dimarbed.
the foUowin, procedure is pen for obtaininJ blade angle: 1. The blade ansle (Refer to Table VlIA-1) is dcurmined by placing a propeller protractor on the face side of the propeller. at the 30 inch sation. u measured from the hub center line. The blade must be horizontal. . 2. The low pitch nop adjustment is made by a screw in the nose of the propeller eylinder. Roatmg the screw clockwise increases the low pitch and reduces the scarie RPM by about 100 RPM for each half cum; or vice versa. b. After the low Ditch stop hu been adjusted for proper blade qie. the govemor should then be adjusted to obtain max~um rated e.e RPM durin, take-off and climb u dcscnbcd ui para,raph 7A·27. 7.-\-22.
Blade Track. Blade luck is the ability of olle blade tip to foUow the other. while rotaring. in almost the sante plane. Exceuive difference in blade track· more than .0625 inch· fRay be an indication of bent blades or Improper propeller installation. Check blade traCk as foUows: a. With the enr'ne shut down and blades Yertical. secure to the aircraft a smooth board JUSt under the tip of the lowe: blade .. "'oYe the tip fore and aft through itS full "blade1hake" mvel. makmg small marks WIth 1 pencil at each position. Then centct the tip betwccn these marks and scribe a line on the board for the fuil width of the tip. b. Carefully rotate propeller by hand to bring the opposite blade down.
Center the tip and scribe a pencil line as before lnd check that lines arc not separated more than .062' inch. c. Propellers haVIng excess blade track should be removed and inspected for bent blades or for parts of sheared "0" nng. or foretln panicles. which haye lodged betWccn hub and crankshaft mounting faces. Bent blades will require rcpw and overhaul of assembly. POWER PLANT ISSUED: 8/18/72 2 C13