BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMANCHE SERVICE MANt:AL 7A-51. Adjustment Of Carburetor Controls. (Refer to Figure 7-6a.) The throttle mixture and carbure. heat controls are adjust.ed so that ,;,'hen the throttle arm ?n t~e carbu:retor is rotated forward against it'> throttle stop and th.. mixture arm IS rotated forward against Its full rich stop and the carburetor heat arm is rotated to the full ram air position. their respective cockpit controls should be .062 of an inch OUt from their full forward stops, a. Disconnect throttle control cable at the carburetor and loosen the jam nut securing the cable end. b. Adjust the linkage by rotating:

the cable end to obtain the .062 of an inch spring back 01 the cockpit control when the throttle arm contacts it stop. c. Reconnect the cable end to the control arm and secure jam nut. d. Adjust mixture and carburetor heat control by loosening the castelled nut at the control arms and sliding control cable through the stud until the .062 of an inch spring back of the cockpit control is obtained when the mixture is in the full rich position and the carburetor heat is in the full ram air position. e. Tighten caste lied nut and safety. f. Pull the throttle.

mixture and carburetor heat controls in the cockpit full aft to ascertain that the throttle arm contacts the idle screw and the mixture control arm contacts its idle cut-off stop and the carburetor heat flap valve is in the full carburetor heat position. 7 A·5"}', Adjustment Of Idle Speed And Mixture. (Carburetor) a, Start the engine and warm up in the usual manner until oil and cylinder head temperatures are normal. b. Check magnetos. If the "mag-drop" is normal. proceed with idle adjustment. c. Close the throttle to idle. If the RPM changes appreciably after making the idle mixture adjustment during the succeeding steps. readjust the idle speed to the desired RPM.

The idle mixture must be adjusted with the fuel boost pump ··O~". d. When the idling speed has been stabilized. move the cockpit mixture control with a smooth. steady pull toward the "Idle Cut·OW· position and observe the tachometer for any change during. the "leaning process. Caution must be exercised to return the mixture control to the "Full Rich" position before the RPM can drop to a point where the engine cuts out. An increase of more than 50 RPM while "leaning OUt" indicates an excessively rich idle mixture. An immediate decrease in RPM (if not preceded by a momentary increase) indicates the idle mixture is too lean. ;\;OTE e.

If the above indicates that the idle adjustment is too rich or too lean. turn the idle mixture adjustment in the direction required for correction. and check this new position by repeating the above procedure. Make additional adjustments as necessary. Each time the adjustment is changed. the engine should be run up to 2000 RPM to clear the engine before proceeding with the RPM check. Make final adjustment of the idle speed adjustment to obtain the desired idling RPM with closed throttle. The above method aims at a setting that will obtain maximum RPM with minimum manifold pressure. In case the setting does not remain stable. check the idle linkage:

any looseness in this linkage would cause erratic idling. In all cases. allowance should be made for the effect of weather conditions and field altitude upon idling adjust rnent. ISSt'ED: 8/18/72 2D12 POWER PL.-\.