BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMANCHE SERVICE MANUAL 7 A-H. Fuellnjee:tor. i A·' S. Fuellnjel:tor Maintenance. a. In aencn.l. little attention is required between injector overllauis. However. it is recommended that the foilowitll items be checked during periodic: inspection of the enpne. 1. Check tightnas and lock of all nud and screws which fasten the injector to the e"line. Z. Check ail fuel lines for tightness and evidence of It&kase. A sliJht fuel stain adjacent to the air bleed noules is not cause for concern. 3. Check throttle and mixture control rods and levers,for tiJbmess and lock. 4. Remove and clean the injector fuel inlet srraincr at the (Int Z5 hour iNpection and each 50 hour inspeCtion thereafter.

Damaged strainer "0" rinp should be replaced. Torque strainer to 65·10 inc:h pounds. b. Tests prove that .asoline which becomes stale due to prolonccd stOnce absorbs oxygen rapidly. This stale OXIdized gasoline acquires a very distinctive odor similar to varnish. causes rapid deterioration of synthetic rubber pans. and also forms a JWTImy deposit on the intcma.l meta! parts. This condition. however. does not occur during normal operation of the injeCtor where fresh fuel is being constantly circulated. i.0\-'6. Lubrication Of Fucllnjec:tor. a. There is ye~ little need for lubrication "f the injector in the field bcnveen regular overhauls.

However, the clevis pIns used in connection with the thronle and manual mixture ecnerol tevers should be checked for freedom of movement and lubricated, if necessary. b. Place a drop of enllne pde oil on the end of the thronle shaft in such a manner that it can work into the throttle shaft buShings. iA-.5i. Removal Of Fuel Injector. a. Remove the lower cowling as described in puaJl'aphs 7 A·S or 7A-8. b. Disconnect the throttle and mIxture conttol cables at the injector ueie, c. Disconnect fuel lines at Injector unit. d. Remove the Injector from the engine sump by removing pa1locknutS, nuts and washers. e. Cat safety wire .1nli remove bolts attaciung the air box to the injector unit. iA-S8.

Preparation Of Fuel Injector For Shippi",. Any unit taken OUt of service. or unitSbeing returned for overhaul. must be flushed with preserving oil (SpecIfication ~IL-o~81. Grade 1010), USln! the tollowlng procedures: a. Remove plugs and drain ail fuel from the injector. If available. apply 10 to IS psi air pressure to tne fuei Inlet until all fuel is discnarged from the injector. b. Replace plugs and appl~' flushing all filtered through a 10-micron tilter 3t 13-15 psi to the injector fuel inlet until all is discharged from the outlet. c. Repiace fuel inlet shIpping plug. POWER PLANT ISSUED: i/18f72 2 013