BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMANCHE SERVICE MANUAL 7A·65. Cle.ning.nd Inspection of Fuel Air Bleed Nozzles. . a. Clean th~ ~ozzles ~ith .acetone o~ Methylethylketone (MEK) and blowout all foreign panicl wah compressed air In the direction opposite that of fuel flow. Do not use wire or other hard objects to clean orifices. b. Inspect the nozzle and cylinder threads for nicks. stripping or cross-threading and battered or rounded hexagons. c. Inspect and replace nozzle O·rings found to be cracked. brittle or distorted. Refer to Lycoming Service Instructions 11'40. 1275 for detailed test procedure of air bleed nozzles. 7A·66. Inst.lation of Fuel Air Bleed Nozzle. a.

It is important for the nozzles -to be correctly positioned with the air bleed hole facing upward. b. Install the nozzles and tighten to a little less than 60 inch-pounds torque. c. Continue to tighten the nozzles until the letter or number stamped on the hex of the nozzle body points down. In this position the air bleed hole will face upward. NOTE Do not exeed 60 inch-pounds torque on nozzles when aligning air bleed hole. d. Connect fuel line to nozzle. CAUTION CAUTION Start nozzles and line couplings by hand to prevent the possibility of cross-threading. e. Install engine cowling. 7A·67. Ignition System 7A·68. Magneto.

Ascertain that the primary circuits of both magnetos are grounded before working on the engine. 7A..69. Inspection Of Magnetos. At time of engine inspection or when a magneto has been removed from the engine. the following checks may be performed. Each step in the check list is keyed by number to a part shown in Figure 7A-14. I. Inspect distributor block contact springs. If broken or corroded. they should be replaced. 2. Inspect oil felt washer. It should be saturated with oil. If dry, check for worn bushing. If O.K.• add No. 30 oil. 3. Inspect distributor block for cracks or burned areas. The wax coating on the block should not be removed. Do not use solvents. 4.

Look for excess oil in breaker compartment. If present. it may mean a bad oil seal or oil seal bushing at drive end. Check manufacturer's overhaul procedure. 5. Look for frayed insulation or broken wire strands in leads in back of magneto. See that terminals are secure. Be sure wires are properly positioned. The position of the leads in the 200 series breaker compartment must be as shown in Figure 7A-IS, otherwise. chafing or breaking may result. . POWER PLANT 2D18