BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMANCHE SERVICE MANUAL 1 CONTACT SPRING 2 RETAINING SPRING 3 DISTRIBUTOR BLOCK 4 BREAKER COMPARTMENT S LEAD WIRE 6 CAPACITOR 7 BREAKER ASSEMBLY 8 BREAKER CAM 9. IMPULSE COUPLING 10 FLYWEIGHTS 11. RIVETS 12. lEAD QFlCUlT 13. CONTACT SPRING 1. INSULATOR 15 VENT PLUG Figure 7A·14. Magneto Inspection 6. Inspect capacitor visually. If pOSlible. test for Ink capacity and series resistance. Remember, an electrical failure of an airaaft capacitor is rare. 7. Adjustment of breaken must be correct for proper internal timinl of magneto. (Refer to pU'Faph iA·71.) 8. Check if breaker am is clean and smooth. if am screw is acht CZ5 in. lbs). If nC'W points are installed. blot a little oil on cam.

9. Inspect impulse coup lin, (-n mllfteto) flywqhts for excessive looseness on the axles. Design couplinrs havinJ .927 inch thick body should be checked with 1/8 inch drill. Couplings with .974 inch thicle. body are checked with a No. 18 Crill. If drill fiu betWeen cam and flywei&ht. the fit is too loose and coupline should be replaced. (Refer to Fipre 7 A-16.) 10. Check impulse couplinC for excess wear on the contact ed,es of body and flyweilha. 11. Check that the impulse coupliq flYWeilbt axie rivetS are tifht and there are no cracks in body. 12. Check lad. conduits for &ayed or broken areas of braid due to exc:essive wear and replace where deemed necessary. 13.

Check the sprinp for breaks. corrosion. or defonnation. If possible. check continuity from block with tester or litht. 14. Check insulato" for cracks, breaks or deterioration due to ace. Ascertain insulators are clean. 15. Timine and ventilator plup. Ventilator has drilled holes and should be in lowest hole in magneto to serve also as dwn for excess water or oil. Solid plug is used in other hole - or in location exposed to rain or water. REVISED: 4/10/81 POWER PLANT 2D19